Bedienungsanleitung Mercedes GLS 2018 (Seite 325 von 398) (Englisch)

703622

325

Zoom out

Zoom in

Vorherige Seite

1/398

Nächste Seite

with Canadian law, some U.S. garage door open-

ers also feature a "break".

Proceed as follows:

if you live in Canada.

if you have difficulties programming the

garage door opener (regardless of where you

live) when following the programming steps.

Press and hold one of buttons ; to ? on the

integrated garage door opener.

After a short time, indicator lamp : lights up

yellow.

Release the button.

Indicator lamp : flashes yellow.

Press button B of garage door remote con-

trol A for two seconds, then release it for two

seconds.

Press button B again for two seconds.

Repeat this sequence on button B of remote

control A until indicator lamp : lights up

green.

When indicator lamp : lights up green: pro-

gramming is finished.

When indicator lamp : flashes green: pro-

gramming was successful. The next step is to

synchronize the rolling code.

Release button B of remote control A of the

garage door drive.

When indicator lamp : lights up red: repeat

the programming process for the correspond-

ing button on the rear-view mirror. When

doing so, vary the distance between remote

control A and the rear-view mirror.

The required distance between remote con-

trol A and the integrated garage door opener

depends on the garage door drive system.

Several attempts might be necessary. You

should test every position for at least

25 seconds before trying another position.

Problems when programming

If you are experiencing problems programming

the integrated garage door opener on the rear-

view mirror, take note of the following instruc-

tions:

Check the transmitter frequency used by

garage door drive remote control A and

whether it is supported. The transmitter fre-

quency can usually be found on the back of

remote control A for the garage door drive.

The integrated garage door opener is com-

patible with devices that have units which

operate in the frequency range of 280 to

433 MHz.

Replace the batteries in garage door remote

control A. This increases the likelihood that

garage door remote control A will transmit a

strong and precise signal to the integrated

garage door opener.

When programming, hold remote control A

at varying distances and angles from but-

tons ; to ? which you are programming. Try

various angles at a distance between 2and

8 inches (5to 20 cm) or at the same angle but

at varying distances.

If a further remote control A is available for

the same garage door drive, repeat the same

programming steps with this remote control

A. Before performing these steps, make sure

that new batteries have been installed in

garage door drive remote control A.

Note that some remote controls only transmit

for a limited amount of time (the indicator

lamp on the remote control goes out). Press

button B on remote control A again before

transmission ends.

Align the antenna cable of the garage door

opener unit. This can improve signal recep-

tion/transmission.

Opening/closing the garage door

After it has been programmed, the integrated

garage door opener performs the function of the

garage door system remote control. Please also

read the operating instructions for the garage

door system.

Turn the SmartKey to position 2 in the igni-

tion lock (

Y page 140).

Press button ;, = or ? which you pro-

grammed to operate the garage door.

Garage door system with a fixed code: indi-

cator lamp : lights up green.

Garage door system with a rolling code: indi-

cator lamp : flashes green.

The transmitter will transmit a signal as long

as the button is pressed. The transmission is

halted after a maximum of ten seconds and

indicator lamp : lights up yellow.

Press button ;, = or ? again if necessary.

Features

323

Stowage and features

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes GLS 2018 Seite 325

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mercedes GLS 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info