Bedienungsanleitung Mercedes GLS 2018 (Seite 344 von 398) (Englisch)

703622

344

Zoom out

Zoom in

Vorherige Seite

1/398

Nächste Seite

compressor from the stowage well under-

neath the cargo compartment floor

(

Y page 339).

Affix part : of the TIREFIT sticker to the

instrument cluster within the driver's field of

vision.

Affix part ; of the TIREFIT sticker near the

valve on the wheel with the defective tire.

Pull connector ? with the cable and hose A

out of the tire inflation compressor housing.

Screw hose A onto flange B of tire sealant

bottle :.

Place tire sealant bottle : head down into

recess ; of the tire inflation compressor.

Remove the cap from valve C on the faulty

tire.

Screw filler hose D onto valve C.

Insert connector ? into a socket in your vehi-

cle.

Cigarette lighter socket: (

Y page 312)

12 V sockets: (

Y page 312)

Observe the notes on the cigarette lighter

(

Y page 312). Observe the notes on sockets

(

Y page 312).

Turn the SmartKey to position 1 in the igni-

tion lock (

Y page 140).

Press on and off switch = on the tire inflation

compressor to I.

The tire inflation compressor is switched on.

The tire is inflated.

First, tire sealant is pumped into the tire. The

pressure can briefly rise to approximately

500 kPa (5 bar/73 psi).

Do not switch off the tire inflation com-

pressor during this phase.

Let the tire inflation compressor run for a

maximum of five minutes. The tire should then

have attained a pressure of at least 180 kPa

(1.8 bar/26 psi).

If a pressure of 180 kPa (1.8 bar/26 psi) has

been attained after five minutes, see "Tire pres-

sure reached" (

Y page 343).

If a tire pressure of 180 kPa (1.8 bar/26 psi) has

not been attained after five minutes, see "Tire

pressure not reached" (

Y page 342).

If tire sealant has escaped, clean it off affected

areas as quickly as possible. It is preferable to

use clean water.

If your clothes are soiled with tire sealant, have

them cle

aned w

ith perchloroethylene at a dry

cleaner as soon as possible.

Tire pressure not reached

If a pressure of 180 kPa (1.8 bar/26 psi) has not

been attained after five minutes:

Switch off the tire inflation compressor.

Unscrew the filler hose from the valve of the

faulty tire.

Note that tire sealant may escape when you

unscrew the filler hose.

Very slowly drive forwards or reverse approx-

imately 30 ft (10 m).

Pump up the tire again.

After a maximum of five minutes the tire pres-

sure must be at least 180 kPa (1.8 bar/

26 psi).

WARNING

If the required tire pressure is not reached

after the specified time, the tire is too badly

damaged. The tire sealant cannot repair the

tire in this instance. Damaged tires and a tire

pressure that is too low can significantly

impair the vehicle's braking and driving char-

acteristics. There is a risk of accident.

342

Flat tire

Breakdown assistance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes GLS 2018 Seite 344

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mercedes GLS 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info