Bedienungsanleitung Mercedes S-Class 2017 (Seite 365 von 382) (Englisch)

703593

365

Zoom out

Zoom in

Vorherige Seite

1/382

Nächste Seite

Always observe the instructions and safety

notes in the "Mounting a wheel" section

(

Y page 363).

The wear patterns on the front and rear tires

differ, depending on the operating conditions.

Rotate the wheels before a clear wear pattern

has formed on the tires. Front tires typically

wear more on the shoulders and the rear tires in

the center.

On vehicles that have the same size front and

rear wheels, you can rotate the wheels accord-

ing to the intervals in the tire manufacturer's

warranty book in your vehicle documents. If no

warranty book is available, the tires should be

rotate every 3,000 to 6,000 miles (5,000 to

10,000 km). Earlier may be necessary, depend-

ing on the degree of tire wear. Do not change the

direction of wheel rotation.

Clean the contact surfaces of the wheel and the

brake disc thoroughly every time a wheel is rota-

ted. Check the tire pressure and, if necessary,

restart the tire pressure loss warning system

(

Y page 352) or the tire pressure monitor

(

Y page 351).

Direction of rotation

Tires with a specified direction of rotation have

additional benefits, e.g. if there is a risk of hydro-

planing. These advantages can only be gained if

the tires are installed corresponding to the

direction of rotation.

An arrow on the sidewall of the tire indicates its

correct direction of rotation.

Storing wheels

Store wheels that are not being used in a cool,

dry and preferably dark place. Protect the tires

from oil, grease, gasoline and diesel.

Mounting a wheel

Preparing the vehicle

Stop the vehicle on solid, non-slippery and

level ground.

Apply the electric parking brake manually.

Bring the front wheels into the straight-ahead

position.

Shift the transmission to position P.

Make sure that the vehicle level is set to "Nor-

mal" for AIRMATIC (

Y page 182) or Active

Body Control (ABC) (

Y page 180).

Switch off the engine.

Open the driver's door.

The vehicle electronics now have status 0.

This is the same as the SmartKey having been

removed.

Remove Start/Stop button from ignition lock

(

Y page 145).

or, if the SmartKey is inserted in the ignition

lock:

Remove the SmartKey from the ignition lock.

Make sure that the engine cannot be started

via your smartphone (

Y page 147).

If included in the vehicle equipment, remove

the tire-change tool kit from the vehicle.

Safeguard the vehicle against rolling away.

Securing the vehicle to prevent it from

rolling away

If your vehicle is equipped with a wheel chock, it

can be found in the tire-change tool kit

(

Y page 327).

The folding wheel chock is an additional safety

measure to prevent the vehicle from rolling

away, for example when changing a wheel.

Fold both plates upwards :.

Fold out lower plate ;.

Guide the lugs on the lower plate fully into the

openings in base plate =.

Changing a wheel

363

Wheels and tires

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes S-Class 2017 Seite 365

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mercedes S-Class 2017

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info