Bedienungsanleitung Mercedes S-Class Sedan - 2015 (Seite 473 von 502) (Englisch)

624700

473

Zoom out

Zoom in

Vorherige Seite

1/502

Nächste Seite

Place the ratchet wrench onto the hexagon

nut of the jack so that the letters AB are

visible.

Turn the ratchet wrench until the vehicle is

once again standing firmly on the ground.

Place the jack to one side.

Tighten the wheel bolts evenly in a cross-

wise pattern in the sequence indicated (:

to A). The tightening torque must be

110 lb-ft (150 Nm).

Turn the jack back to its initial position.

Stow the jack and the rest of the vehicle

tools in the trunk again.

AMG vehicles and vehicles with AMG

equipment: insert the cover into the outer

sill.

Check the tire pressure of the newly moun-

ted wheel and adjust it if necessary.

Observe the recommended tire pressure

(Y page 445).

Vehicles with a tire pressure control sys-

tem: all mounted wheels must be equipped

with functioning tire pressure control sen-

sors.

Wheel and tire combinations

General notes

For safety reasons, Mercedes-Benz rec-

ommends that you only use tires and

wheels which have been approved by

Mercedes-Benz specifically for your vehi-

cle.

These tires have been specially adapted for

use with the control systems, such as ABS

or ESP

, and are marked as follows:

MO = Mercedes-Benz Original

MOE = Mercedes-Benz Original Extended

(tires featuring run-flat characteristics)

MO1 = Mercedes-Benz Original (only cer-

tain AMG tires)

Mercedes-Benz Original Extended tires

may only be used on wheels that have been

specifically approved by Mercedes-Benz.

Only use tires, wheels or accessories tes-

ted and approved by Mercedes-Benz. Cer-

tain characteristics, e.g. handling, vehicle

noise emissions or fuel consumption, may

otherwise be adversely affected. In addi-

tion, when driving with a load, tire dimen-

sion variations could cause the tires to

come into contact with the bodywork and

axle components. This could result in dam-

age to the tires or the vehicle.

Mercedes-Benz accepts no liability for

damage resulting from the use of tires,

wheels or accessories other than those tes-

ted and approved.

Information on tires, wheels and approved

combinations can be obtained from any

qualified specialist workshop.

Overview of abbreviations used in the follow-

ing tire tables:

BA: both axles

FA: front axle

RA: rear axle

The recommended pressures for various

operating conditions can be found:

on the Tire and Loading Information placard

with the recommended tire pressures on

the B-pillar on the driver's side

in the tire pressure table on the inside of the

fuel filler flap

Observe the notes on recommended tire

pressures under various operating conditions

(Y page 445).

Check tire pressures regularly, and only when

the tires are cold. Comply with the mainte-

nance recommendations of the tire manufac-

turer in the vehicle document wallet.

Wheel and tire combinations

471

Wheels and tires

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes S-Class Sedan - 2015 Seite 473

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info