657615
121
Zoom out
Zoom in
Vorherige Seite
1/139
Nächste Seite
117
28.3.3 Mounting the full carbon fork with
carbon steerer
Cutting the steerer tube, pressing the seat
mounting of the cone bearing and mounting
the fork to the frame, are jobs best left to an
expert. These steps are to be carried out by
authorized MERIDA dealers only. Otherwise
the warranty will become void.
Each of the following instructions
must be followed strictly. Non-observ
-
ance of these instructions can cause the fork
to fail and lead to a crash with serious con-
sequences.
The inner diameter of the headset crown
race must fit the diameter of the crown
of the carbon fork. With 1 1/8”- forks,
the steerer crown race diameter is 30 ±
0.05mm.
tion and until any gap between bearing
and fork head has disappeared. Keep the
fork in hand during hitting and do not put
it down – risk of breakage!
28.3 Carbon forks
Usually, the aluminium bearing seat on
every fork is prepared. If additional work
is necessary nevertheless, only use a sui-
table milling tool for preparing the cone
bearing seats. Sharp-edged or blunt tools
can notch the bearing seats and make the
steerer tube fail.
Clean the contact area of cone and fork
seat and apply a little grease. Hit the cone
bearing seat with an appropriate special-
purpose tool until it is in a horizontal posi-
To cut the fork, do not put it into a vice
as this could damage the shaft. Clamp the
steerer tube with an appropriate device
(e.g. a special vice) and use a sharp metal
saw blade to saw it. Saw with low pressu-
re and remove the burrs with a small file.
121

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Merida 2008 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info