784468
14
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
Overheating safe device
Your appliance is fitted with a safety device that switches off the heater in the event of overheating.
If the heater stops working, turn the heater off and check if the inlet or outlet is blocked. Disconnect the plug and wait
at least 10 minutes for the protection system to reset before attempting to restart the heater. If the security switch
still switches the heater off and prevents the heater from operating, take the heater to your nearest service centre for
examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at least 10 minutes.
The figure in the marking means: “WARNING: DO NOT COVER.”
Warning: This heater is not equipped with a device for checking room temperature. Do not use this heater in small
rooms if they are occupied by people who cannot leave the room on their own, unless constant supervision is provided.
Cleaning
1. Always disconnect the appliance from the main power supply and make sure the appliance has completely
cooled down before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum, another detergent or chemical solvents to clean the heater.
4. If the heater is not used for a long time, it should be protected from dust and stored in a clean, dry place.
Disposal
Environmental Protection
Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal (household) waste; use separate collection
facilities (2012/19/EU). Contact your local government for information regarding the available collection
systems. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into
the groundwater and enter the food chain, thus damaging your health and well-being. When replacing old appliances
with new ones, the retailer is legally obligated to take back your old appliance for disposal free of charge.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MKK-300 (YH-08), applies all basic requirements and other
relevant regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage
directive (2014/35/EU). If you require a full declaration of conformity, you can contact the address listed on the
backside of this manual.
ENGLISH
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mestic MKK-300 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info