Bedienungsanleitung Mestic MPM 20 (Seite 9 von 32) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch)

784466

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

ENGLISH

Installation

1. Connect the negative terminal of the battery to the negative connector of your caravan mover.

2. Connect the positive terminal of the battery to the positive connector of your caravan mover.

3. It is recommended to use a cable of at least 16 mm2. Use a red cable for the + and a black cable for the -. Always

follow the manual of your caravan mover when connecting the cabling.

Use

1. The battery has more than enough capacity to carry out one manoeuvre of the caravan with a mover. It is

recommended to recharge the battery after each use for the next use.

2. The battery is capable of delivering short, high currents to overcome a threshold or other obstacles. If this is

done for a longer period of time, the battery will turn off automatically and must reset itself.

3. Unlike lead-acid batteries, it is possible to fully discharge this lithium battery with LiFePO4 technology. This

means 100% of the battery capacity can be used.

4. When the battery is empty, it will turn itself off and must be charged before the next use. Charging takes place

via a charging cable and mains connection.

5. Optionally available is a charger (car charger) that uses the car voltage to slowly charge the battery while driving.

With this, it is no longer necessary to install thick cabling.

6. The battery can be securely mounted on a supporting structure by means of the bottom mounting.

7. If you are not using the battery for a longer period of time, it is strongly recommended to disconnect the battery

terminals. Make sure that the battery does not run out because it is in standby mode. Also make sure that the

battery is not connected to the mains. If the temperature is below 0 ° C it should not be charged. The battery

can be stored this way for up to a year, due to its very low self-discharge.

How to charge the Powerpack

charging with an AC adapter

The battery can be charged by connecting the supplied connection cable to the power supply.

• Connect the other end of the connection cable to the DC input port on the device. With the charging function

of the adapter input, the voltage range is 12V DC - 24V DC.

Correct disposal of this product.

This symbol indicates that this product must not be disposed of together with normal household waste

(2012/19/EU). To prevent possible harm to the environment or human health from uncontrolled waste

disposal, recycle it responsibly to promote sustainable reuse of material resources. To return your used

device, please read the warranty terms from where the product was purchased. They can take the

product back for environmentally safe recycling.

Declaration of Conformity

Gimeg Nederland BV hereby declares that the device MPM-12-20-30 meets the basic requirements and other relevant

regulations mentioned in the European directive for electromagnetic compatibility (2014/30/EU) and the directive

relating to environmental EU Compliance (2015/863/EU). You can request a complete declaration of conformity at the

address stated on the back.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mestic MPM 20 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info