Bedienungsanleitung Metabo HWWI 4500-25 (Seite 8 von 64) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

600845

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

ENGLISHen

Original instructions

Under our sole responsibility, we hereby declare

that these pumps/domestic water systems/auto-

matic domestic water systems, identified by type

and serial number *1), comply with all relevant

requirements of the directives *2) and standards

*3). Technical documents for *4) - see page 3.

This device is used for conveying clean water in

the house and garden area, for sprinkling and

watering, as a well pump, rain pump and domestic

water pump and for pumping out swimming pools,

garden ponds and water tanks.

The maximum permissible temperature of the

conveyed medium is 35 °C.

The device must not be used for drinking water

supply or for conveying food supplies.

Explosive, combustible, aggressive or other

substances that are harmful to health must not be

conveyed.

The device is not suitable for commercial or indus-

trial use.

This device is not designed for use by persons

(including children) with limited physical, sensory

or mental aptitude or lack of experience and/or

knowledge.

Unauthorised modifications to the device and the

use of parts that are not tested and approved by

the manufacturer are prohibited.

All improper use of the device is regarded as non-

specified use; this can result in unpredictable

damage! The user bears sole responsibility for any

damage caused by improper use.

Generally accepted accident prevention regula-

tions and the enclosed safety information must be

observed.

For your own protection and for the

protection of your appliance, pay atten-

tion to all parts of the text that are

marked with this symbol!

WARNING – Reading the operating

instructions will reduce the risk of injury.

WARNING Read all safety warnings and

instructions. Failure to follow all safety

warnings and instructions may result in electric

shock, fire and/or serious injury.

Keep all safety instructions and information

for future reference.

Pass on your pump only together with these docu-

ments.

Information in these operating instructions is cate-

gorised as shown below:

Danger! Risk of personal injury or environ-

mental damage.

Risk of electric shock! Risk of personal

injury by electric shock.

Caution! Risk of material damage

Children, adolescents and per-

sons who are not familiar with the

operating instructions must not

use the device.

Children should be supervised to

ensure that they do not play with

the appliance.

When the pump is being used in

swimming pools and garden

ponds and in the protected areas

around them, the provisions of

DIN VDE 0100-702 and -738 must

be observed.

The device must be supplied via a

residual-current device (RCD)

with a rated residual current of

max. 30 mA.

The device must not be used if

there are persons in the water.

When used for domestic water

supply, the statutory water and

waste water specifications

according to DIN 1988 must be

observed.

The following residual risks

essentially remain when operating

pumps and pressure vessels can-

not be fully eliminated (depending

on features) – even if safety meas-

ures have been introduced.

4.1 Danger from the environ-

ment!

Do not expose device to rain. Do

not operate device in a damp or

wet environment.

Do not use the pump in hazardous

areas or near inflammable liquids

and gases!

4.2 Danger: Hot water!

Danger! Install a check valve

at the suction connection

(12)

to prevent water from flowing back

into the suction line. This can

reduce the following danger:

Hot water can cause damage and

leaks on the pump and the con-

nection lines, allowing hot water to

escape. Danger of scalding!

Devices with the designation

HWW...: If the shut-off pressure of

the pressure switch cannot be

reached due to poor pressure

conditions or a defective pressure

switch, the water can heat up

within the pump as a result of

internal circulation.

Devices with the designation P...:

Operate the pump a max. of 5 min-

utes against the closed discharge

line. Water that circulates inside

the device is heated up.

In the event of a fault, unplug the

pump from the power-supply sys-

tem and allow to cool. A specialist

must check the system to make

sure it is in perfect working order

before it can be used again.

4.3 Danger! Risk of electric

shock!

Never direct the water jet directly

at the device or other electrical

components! Risk of fatal electric

shock!

Prior to installation and mainte-

nance tasks, always disconnect

the device from the power-supply

system.

Do not touch the plug with wet

hands! To disconnect, always pull

on the plug, not the power cable.

Do not buckle, squeeze, drag or

drive over power cable or exten-

sion cables; protect from sharp

edges, oil and heat.

4.4 Danger due to device defi-

ciencies or malfunctions!

Before each use, check the

device for possible damage -

especially the mains cable, mains

plug and electrical components.

Risk of fatal electric shock!

A damaged device must only be

reused after it has been correctly

repaired.

Do not attempt to repair the pump

yourself! Only specialists are per-

mitted to repair pumps and pres-

sure vessels (depending on fea-

tures).

Caution! To prevent water

damage, e.g. flooded rooms,

caused by device malfunctions or

deficiencies:

- Introduce suitable safety meas-

ures, e.g.: alarm system or col-

lecting tank with monitor

The manufacturer is not liable for

any damage caused by:

- improper use of the pump;

- overloading of the pump through

continuous operation;

- failure to operate and store the

pump in a frost-free environment;

- unauthorised modification of the

pump (repairs to electrical equip-

ment may only be carried out by

qualified electricians!);

- use of spare parts which have

not been tested and approved by

the manufacturer; or

- use of unsuitable installation

materials (fittings, connection

lines etc.).

Suitable installation materials:

- pressure-resistant (min. 10 bar)

- heat-resistant (min. 100 °C).

When using universal swivel cou-

plings (bayonet couplings), only

use versions with an additional

securing ring to ensure safe seal-

ing.

1. Declaration of Conformity

2. Specified Use

3. General Safety Instructions

4. Special Safety Instructions

Metabo HWWI 4500-25 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info