585248
12
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
12
ENGLISH
BDanger! Risk of electric shock!
Do not touch the plug with wet hands! To un-
plug always pull on the plug, not the power
cable.
Connect only to an earthed outlet that is
properly installed, earthed and tested. Mains
voltage and fuse protection must correspond
to those stated in the 'Technical Specifica-
tions'.
Always lift and transport the pump by the
handle, never by the power cable or dis-
charge hose.
Extension cables must have sufficient con-
ductor cross sections. Unroll cable reels ful-
ly.
Do not buckle, squeeze, drag or drive over
power cable or extension cables; protect
from sharp edges, oil and heat.
Place extension cable so that it can not get
into the fluid to be pumped.
Always unplug before servicing the pump.
BRisk of electric shock from pump
faults!
Before each use check the equipment, espe-
cially the power and extension cables, power
plug and float switch for possible damage.
Risk of fatal electric shock!
Do not attempt to repair the pump yourself!
When repaired inexpertly there is a hazard of
liquid entering the electrical parts of the
pump.
A Caution!
To avoid water damage, e.g. flooded
rooms, caused by pump malfunctions or
defects:
provide for suitable safety measures such
as the following:
alarm or
collection tank with monitoring.
The manufacturer is not liable for any dam-
age caused by:
improper use of the pump;
overloading of the pump through conti-
nous operation;
failure to operate and store the pump in a
frost-free environment;
unauthorised modification of the pump (re-
pairs to electrical equipment may only be
carried out by qualified electricians!);
use of spare parts which have not been
tested and approved by the manufacturer;
or
use of unsuitable installation materials (fit-
tings, connection lines etc.).
Suitable installation materials:
pressure-resistant (min. 10 bar)
heat-resistant (min. 100°C).
4.1 Assembling the handle / lift-
ing eye
1. Bring the two halves of the handle (10) to-
gether as illustrated above.
Run the power supply cable (11) and float
switch cable (12) out the top.
2. Join the two halves of the handle (10). En-
sure that the guides on the two handle
parts engage.
3. Secure the handle with the four screws (9)
to the pump casing (13). Use the supplied
screws only.
4.2 Connecting the discharge line
4. Assembly and Installation
9
10
11
10
13
12
PS 18000 SN All other models
15
15
G 1"
1¼"
1½"
1"
G 1"
1¼"
16
16
14
14
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Metabo PS15000S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info