MX 20
34
3.3 - BATTERIES INSTALLATION - FUSE REPLACEMENT3.3 - BATTERIES INSTALLATION - FUSE REPLACEMENT
3.3 - BATTERIES INSTALLATION - FUSE REPLACEMENT3.3 - BATTERIES INSTALLATION - FUSE REPLACEMENT
3.3 - BATTERIES INSTALLATION - FUSE REPLACEMENT
The sealed compartment (sealed from both inside and outside of
the instrument) is located under the removable protective cover.
To access the compartment:
- Unlatch the SECUR’X system by inserting the instrument
support strut in the sides and then remove it. This ensures that the
test leads are disconnected.
- Release the protective cover by inserting the instrument
support strut into the sides of the instrument (at the places marked
by the arrows) and by applying moderate pressure.
See exploded view at the end of the manual
Insert the battery, ensuring correct polarity by matching + and -
signs, and replace the cover making sure that the watertight seal
remains clean (no solid particles, grit or other particulates) and is
positioned correctly. Finally snap the SECUR’X system in place.
3.4 - SWITCHING ON3.4 - SWITCHING ON
3.4 - SWITCHING ON3.4 - SWITCHING ON
3.4 - SWITCHING ON
· Set the rotary switch to the required measurement function. The
instrument is then ready for use.
3.4.1 - AUTOMATIC/MANUAL RANGING3.4.1 - AUTOMATIC/MANUAL RANGING
3.4.1 - AUTOMATIC/MANUAL RANGING3.4.1 - AUTOMATIC/MANUAL RANGING
3.4.1 - AUTOMATIC/MANUAL RANGING
· When used as a voltmeter and ohmmeter, the instrument is in
autoranging mode when first switched on. Manual ranging is not
recommended unless the order of magnitude of the quantity to be
measured has first been determined in autoranging mode.
