INSTALLING THE USB DONGLE :
- Simply connect the USB Dongle (1) to a free USB port on your PC. A blue light
conrms the connection (3).
- The rst time you install the USB Dongle, the drivers installation will start automa-
tically within 10 seconds. The end of the installation is conrmed when a message
about the new peripheral being ready to start appears.
- If you insert the USB Dongle (1) to the USB port, you will automatically deactivate
the analogue outlet of the sound.
- When the sound is transmitted by the USB Dongle, the blue light will ash.
INSTALLING THE RECEIVER :
To avoid an acoustic shock, please follow these steps to the letter:
- Connect the receiver (2) to your Hi-Fi using the jack / RCA cable (provided). This is
normally done on the AUX channel.
- Turn the volume of the channel to the minimum and select the AUX input.
- Connect the receiver to the mains.
- Turn the switch on the ON position (8).
- Turn the volume of the channel up.
CHOOSING THE CHANNEL :
- To avoid interferences with other pieces of electrical equipment that work on the same
frequency, you can change the channel. In order to do so, press the small switch on
the side of the USB Dongle (4). The headphones receiver will automatically adjust on
the new channel.
IN CASE OF A PROBLEM :
1 - There is no sound coming out of the Hi-Fi :
- Ensure that the blue and orange lights of the receivers are switched on.
- Ensure that the blue light of the USB Dongle is ashing (if not, this means that no
sound is diffused by your PC).
- Ensure that the channel is AUX.
2 - The sound is disrupted :
- Try another channel (see above).
- To increase the reach of the USB Dongle, you can use a USB entension.
