Now you can close the cover again.
Next step is to make the controller.
Bend the first seven contacts of the switch about 90 degrees in the outer direction.
Connect one end of the resistors with the contacts of the switch.
● Contact 1 – 2.2M ohm – Full power
● Contact 2 – 56K ohm - 1/2 power
● Contact 3 – 22K ohm - 1/4 power
● Contact 4 – 15K ohm - 1/8 power
● Contact 5 – 10K ohm - 1/16 power
● Contact 6 – 5,6K ohm - 1/32 power
● Contact 7 – 3,9K ohm - 1/64 power
Connect the other ends of the resistors with each other.
Take a piece of diode cable of approx. 30 inch and connect the male connector at one end.
On the other end make loose knot at about seven inches from the end.
Connect one wire with the middle contact of the switch and the other wire with the the place
where the resistors are connected with each other.
