517338
89
Zoom out
Zoom in
Vorherige Seite
1/174
Nächste Seite
89
ķ
TTL flash mode
This analogue flash mode is supported by older analogue cameras.
It is the normal TTL flash mode (TTL flash mode without preflash).
Setting procedure
• Press „Mode“ until „ flashes in the
display.
The setting takes effect immediately.
After about 5 seconds the display stops
flashing and the setting is saved
automatically.
“ appears in the display.
The normal TTL flash mode cannot be set on cameras supporting E-TTL or
E-TTL-II flash modes!
Some Powershot camera models support only the manual flash mode
“ in the camera mode manual M!
In this case, „E “ cannot be used.
Automatic TTL and E-TTL Fill-in flash mode
The automatic TTL or E-TTL fill-in flash mode is activated by most cameras when
the automatic programme P is selected and by Vari or subject programmes
during daylight (see camera operating manual).
Fill-in flash mode overcomes troublesome shadows and produces a more balan-
ced exposure between subject and background with contre-jour shots.
The camera’s computer-controlled metering system sets the most suitable combi-
nation of shutter speed, aperture and flash output.
Ensure that the contre-jour light source does not shine directly into the
lens, as this will interfere with the camera’s TTL metering system!
There is no setting or display for automatic TTL fill-in flash in the flash unit.
TTL
M
TTL
TTL
7.2 Manual flash mode
In the manual flash mode M , the flash unit emits the full uncontrolled amount of
light if no partial light output has been selected. The specific photographic situa-
tion can be taken into account by adjusting the aperture setting or by selecting a
suitable manual partial light setting. The setting area ranges from P 1/1 to
P 1/128 in M mode and P1/1 - P1/32 in M-HSS mode. The display shows the
distance at which the subject is correctly lit (see 5.2).
Setting procedure
• Press „Mode“ until „ flashes in the
display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and
the setting is saved automatically. „ “ appears in
the display.
Manual partial light output levels
• In manual flash mode set the partial
light output desired with the buttons
+ and —. The setting takes effect immedia-
tely and is saved automatically.
The distance display is adjusted to the partial
light output automatically (see 5.2).
Various camera models support the manual flash mode only in the
camera mode manual M! In other camera models an error message
appears in the display and the release is locked!
M
M
M
M
F 5,6
6,1
m
Zoom
50
mm
M
M
P 1/4
3,0
m
Zoom
50
mm
M
M
P1/4
F 8,0
4,3
m
Zoom
50
mm
TTL
TTL
709 47 0175.A2 50 AF-1 C 26.08.2010 15:52 Uhr Seite 89
89

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

metz-mecablitz-50-af-1-digital-canon

Suche zurücksetzen

  • Ist der Metz MECABLITZ 50 AF-1 digital Canon auch für die Canon EOS M& Mark II geeignet? Eingereicht am 7-6-2021 19:59

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Metz MECABLITZ 50 AF-1 digital Canon wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info