517345
157
Zoom out
Zoom in
Vorherige Seite
1/286
Nächste Seite
157
k
8 Manual flash exposure correc-
tion
The auto flash exposure mode of most came-
ras is adjusted to a reflection factor of 25%
(the average reflection factor of flash sub-
jects). A dark background that absorbs much
of the light or a highly reflective bright back-
ground (backlit shots, for example) may
result in, respectively, underexposure or
overexposure of the subject.
To offset these effects, the flash exposure
can be adjusted manually for the shot with a
correction value. The extent of the correction
depends on the contrast between the subject
and background!
In TTL flash modes, manual flash exposure
correction factors of from -3 EV (f-stops) to
+3 EV (f-stops) can be adjusted on the flash
unit in one-third increments.
Tip:
Dark subject against light background:
positive correction factor.
Light subject against dark background:
negative correction factor.
Exposure correction by means of alteration of
the lens aperture setting is impossible, since
the camera’s automatic exposure program
regards the altered aperture setting as the
normal working aperture setting.
When setting the correction factor, the
distance shown in the display can change
and be adjusted to the correction factor
(depending on the camera model)!
Setting procedure
• Press the sensor buttons on the touch
display as many times as it takes for the
partial light output selection to appear.
• Press the sensor buttons on the
touch display and set a correction value.
• Press the selected correction value on the
touch display, e.g .
The setting will take effect immediately.
Manual flash exposure correction is only
possible in TTL flash mode if the camera
supports this function (consult the camera’s
operating instructions)!
If the camera does not support this function,
the adjusted correction will have no effect.
For some camera models, the manual flash
exposure corrections must be adjusted on
the camera. If this is the case, no correction
value will appear on the flash unit display.
EV
-1
+
-1 1/3
-1
-2/3
TTL
INFO
EV
0,7-7,9 m
ZOOM 35
F4.0
m
m
TTL
INFO
EV
-1
0,7-7,9 m
ZOOM 35
F4.0
m
m
157

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

metz-mecablitz-52-af-1-nikon-digital

Suche zurücksetzen

  • Bedienungsanleitung Metz mecablitz 52 AF-1 für NIKON Z 6 wird gewünscht. Herunterladen aus dem Internet mit Umständen verbunden ! Vielen Dank für die Ubermittlung einer PDF Datei.
    Frundliche Grüße
    R. Jung Eingereicht am 26-10-2020 13:43

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Metz Mecablitz 52 AF-1 Nikon digital wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info