Bedienungsanleitung Metz MECABLITZ 54 AF-1 Minolta (Seite 63 von 108) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

517350

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

The extended zoom mode is only possible in the „Auto Zoom“ mode with a

focal length setting of 28 mm and longer. Since the start position of the zoom

reflector is 24 mm, a focal length of less than 28 mm will cause „24 mm“ to

flash on the LC display, thereby warning the user that the required reflector

position for extended zoom mode cannot be set.

Shots with a 24 mm and longer focal length of the lens will be correct-

ly illuminated right out to the image corners also in extended zoom

mode!

Turning on the extended zoom mode

• Continue depressing the „Select“ key combination (= „Mode“ key +

„Zoom“ key) until „Ex“ appears on the LC display.

• Continue depressing the „Zoom“ key until „ON“ flashes on the LC display.

• The setting becomes instantly effective. The LC display is switched back to

its normal state after approx. 5 sec.

After the setting procedure, the „Ex“ symbol for extended zoom mode will

continue to be indicated on the LC display of the flash unit!

Please note that the wider illumination coverage in extended zoom

mode results in a diminished maximum flash range!

Turning off the extended zoom mode

• Continue depressing the „Select“ key combination (= „Mode“ key +

„Zoom“ key) until „Ex“ appears on the LC display.

• Continue depressing the „Zoom“ key until „OFF“ flashes on the LC display.

• The setting becomes instantly effective. The LC display is switched back to

its normal state after approx. 5 sec.

After storage in the memory, the „Ex“ symbol for extended zoom mode will

no longer be indicated on the LC display of the flash unit.

5.7 AF measuring beam

The AF measuring beam is activated by the camera electronics when the am-

bient lighting conditions are insufficient for automatic focusing. The AF beam

projects a striped pattern on to the subject, and the camera uses this pattern

☞

to focus automatically. The AF beam has a range of approx. 6 m to 9 m

(with a 50 mm/f/1.7 standard lens). Parallax error between lens and AF red

light emitter limits the close-up range of the AF measuring beam to approx.

0.7 m - 1 m.

The camera lens must be switched to AF so that the AF measuring

beam can be activated by the camera. The AF mode „Single AF“ or

„ONE-SHOT AF“ must be set on the camera (see the camera’s ope-

rating instructions). Zoom lenses with a lower initial aperture can

significantly reduce the range of the AF measuring beam!

The striped pattern of the AF measuring beam only supports the camera’s

central AF sensor. We therefore recommend to activate only the central AF

metering area on cameras that feature several AF sensors (please refer to the

operating instructions of the given camera).

If a decentral AF sensor is manually selected by the photographer, or auto-

matically by the camera, then the emitter of the AF measuring beam on the

flash unit will not be activated. In such instances some cameras will use their

built-in AF illuminator (see camera manual).

5.8 Triggering control

The camera prevents the triggering of a flash if the ambient light level is suffi-

cient for an exposure in the normal mode. The exposure is then completed

with the shutter speed given in the display or viewfinder of the camera. The

triggering control is activated when the flash-ready signal in the camera’s

viewfinder is extinguished. In this event no flash is fired when the camera’s

shutter is tripped.

On various cameras the triggering control only works in the Program “P”

Mode and in the Shutter Priority Mode “S” (see operating instructions for the

camera). The triggering control can be deactivated on some camera models:

To do so, press and hold down the flash button on the camera during

shooting (see camera manual). The flash-ready signal will again be dis-

played in the camera’s viewfinder when the shutter release is lightly touched.

The camera selects a suitable shutter speed/aperture combination and a

flash is fired when a picture is shot.

☞

54 AF-1 M 03.08.2004 10:53 Uhr Seite 63

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Metz MECABLITZ 54 AF-1 Minolta Seite 63

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info