Bedienungsanleitung Microlife BP N2 EASY (Seite 5 von 67) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

663510

Zoom out

Zoom in

Vorherige Seite

1/67

Nächste Seite

3BP N2 Easy



Only use Microlife cuffs.



When using an L cuff with this device, be sure to only use it

with the corresponding black deflation valve.



Contact your local Microlife Service if the enclosed cuff 4 does

not fit.



Connect the cuff to the device by inserting the cuff connector 7

into the cuff socket 8 as far as it will go.

Connecting the pump ball

Connect the pump ball 6 to the device by firmly inserting the

connector 9 into the pump ball socket AT.



The pump ball and cuff can be placed in either socket 8 or

AT.

3. Taking a Blood Pressure Measurement using this

Device

Checklist for taking a reliable measurement

1. Avoid activity, eating or smoking immediately before the

measurement.

2. Sit down for at least 5 minutes before the measurement and relax.

3. Always measure on the same arm (normally left). It is recom-

mended that doctors perform double arm measurements on a

patients first visit in order to determine which arm to measure in

the future. The arm with the higher blood pressure should be

measured.

4. Remove close-fitting garments from the upper arm. To avoid

constriction, shirt sleeves should not be rolled up - they do not

interfere with the cuff if they are laid flat.

5. Always ensure that the correct cuff size is used (marking on the

cuff).

• Fit the cuff closely, but not too tight.

• Make sure that the cuff is positioned 2 cm above the elbow.

• The artery mark located on the cuff (ca. 3 cm long bar) must

lie over the artery which runs down the inner side of the arm.

• Support your arm so it is relaxed.

• Ensure that the cuff is at the same height as your heart.

6. Switch on the device and wait until «0» appears in the display

and the arrow «» AM starts to flash.

7. Take the pump ball in your free hand (the arm you are not

measuring from) and pump up the cuff. Watch the pressure indi-

cation in the display and pump approx. 40 mmHg higher than

the expected systolic value (the upper value). If you have not

pumped enough, a flashing arrow «» AM will appear telling

you to pump higher.

8. After pumping, the measurement is taken automatically. Relax, do

not move and do not tense your arm muscles until the measure-

ment result is displayed. Breathe normally and do not talk.

9. During the measurement, the pulse indicator AK flashes in the

display.

10.The result, comprising the systolic AS and the diastolic AR

blood pressure and the pulse rate AQ is displayed. Note also the

explanations on further display symbols in this booklet.

11.When the measurement has finished, press the quick-acting

discharge valve 5 in order to release any remaining air in the

cuff. Remove the cuff.

12.Switch off the device. (The monitor does switch off automati-

cally after approx. 1 min.).

4. Appearance of the Pulse Arrhythmia Indicator for

early Detection

This symbol AL indicates that certain pulse irregularities were

detected during the measurement. In this case, the result may

deviate from your normal blood pressure – repeat the measure-

ment. In most cases, this is no cause for concern. However, if the

symbol appears on a regular basis (e.g. several times a week with

measurements taken daily) we advise you to tell your doctor.

Please show your doctor the following explanation:

Cuff size for circumference of upper arm

S 17 - 22 cm

M 22 - 32 cm

L 32 - 42 cm

Information for the doctor on frequent appearance of the

Arrhythmia indicator

This device is an oscillometric blood pressure monitor that also

analyses pulse irregularity during measurement. The device is

clinically tested.

The arrhythmia symbol is displayed after the measurement, if pulse

irregularities occur during measurement. If the symbol appears

more frequently (e.g. several times per week on measurements

performed daily) we recommend the patient to seek medical advice.

This device does not replace a cardiac examination, but serves to

detect pulse irregularities at an early stage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Microlife BP N2 EASY Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info