Bedienungsanleitung Midas DL461 Router (Seite 11 von 64) (Englisch)

658492

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

DL461 Router

Operator Manual

Precautions

Before installing, setting up or operating this equipment, make sure that you have read

and fully understand all of this section and the “IMPORTANT SAFETY INSTRUCTIONS” at

the front of this manual.

This equipment is supplied by a mains voltage that can cause electric shock injury!

The following must be observed in order to maintain safety and electromagnetic compatibility (EMC)

performance.

Safety warnings

Signal 0V is connected internally to the

chassis.

To electrically isolate the equipment,

switch off the mains on/off switch at the

rear of unit. Make sure that the power at

the mains outlet is off, and then disconnect

the mains cable from the mains outlet.

To avoid electrical shock do not remove

covers.

The power supplies - even the DC ones -

have a high current!

General precautions

In the event of ground loop problems,

disconnect the signal screen at one end of the

connecting cables. Note that this can only be

done when the equipment is used within a

balanced system.

Do not remove, hide or deface any warnings or

cautions.

Power

The power supplies contain LETHAL VOLTAGES

greatly in excess of the mains voltage and that

its rails can produce extremely large currents

that could burn out equipment and wiring if

shorted.

The internal power supplies are of the switch

mode type that automatically senses the

incoming mains voltage and will work where the

nominal voltage is in the range 100VAC to

240VAC.

A mains inlet is provided on the rear panel. The

correct lead for connection in the area to which

the unit was shipped is supplied with the unit.

The equipment should only be plugged into the

mains outlet using the supplied lead.

When removing the equipment’s electric plug

from the outlet, always hold the plug itself and

not the cable. Pulling out the plug by the cable

can damage it.

Never insert or remove an electric plug with wet

hands.

Handling the equipment

Completely isolate the equipment electrically

and disconnect all cables from the equipment

before moving it.

Take great care when lifting or moving the

equipment and always take its size and weight

into consideration.

Do not insert your fingers or hand in any gaps or

openings on the equipment, for example, vents.

Avoid inserting or dropping foreign objects, such

as paper, plastic, metal etc., into any gaps or

openings on the equipment, for example, vents.

If this happens, turn off the power immediately

and unplug the power from the AC outlets.

Then have the equipment inspected by the

manufacturer's qualified service personnel.

Installation

Before installing the equipment:

• Make sure the equipment is correctly

connected to the protective earth conductor

of the mains voltage supply of the system

installation through the mains leads.

• Power to the equipment must be via a fused

spur.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Midas DL461 Router Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info