Bedienungsanleitung Midas VeniceU U24 (Seite 98 von 122) (Englisch)

658484

Zoom out

Zoom in

Vorherige Seite

1/122

Nächste Seite

88 Appendix C: Application Notes

VeniceU

Operator Manual

channels will receive the same signal at the same time so, typically, when 16 channels

are summed together a gain of around 5dB to 8dB will be seen. It is important to leave

some headroom in the summing amplifiers so that they do not overload, should the

sum exceed the maximum level.

The effect of EQ

Channel equalisation should be used with care. Boosting or cutting equaliser bands can

make monitoring your actual input level very difficult. Excessive boosting of EQ (+15dB

is available on each band) will have the same effect as applying more gain to the input,

taking up valuable headroom. Consider backing off the channel gain when using large

amounts of boost (if you have to use large amounts of boost) to retain a sensible level

at the output.

Excessive EQ cut can have a similarly undesirable effect. If a large amount of signal is

cut in the equaliser section, gain may be used to ‘make up’ the level lost in the

equaliser. However, the input pre-amplifier still has the same amount of available

headroom. If gain, added to ‘make up’ the loss in the equaliser, exceeds the maximum

level into the microphone pre-amp then the channel won’t appear to be overloaded, but

the microphone pre-amp will. Turning off the equaliser will reveal the true story,

whereby the microphone pre-amp may be overloaded. It is worth considering whether

such large amounts of EQ cut is really required, or whether it is being used rather more

as a volume control (in which case the input gain could be set to a normal operating

level and the output adjusted on the channel fader).

You can monitor the level pre-EQ and post-EQ using the LED meter by switching

the EQ in and out during sound check.

Dynamic processing

When working with signals that are constantly at a high level the channel gain can

accommodate these signals with ease. When working with varying signals, such as

from a vocalist, it may be desirable to reduce the dynamic range of the signal so that

the loud parts aren’t so loud (and don’t overload your channel input) and the quiet bits

aren’t too quiet (so the signal to noise ratio would be increased).

Limiters and compressors have a similar function, which is to reduce the dynamic range

of a signal. The means by which they do this won’t be discussed here, but these

devices have the ability to reduce the level of loud signals automatically and also raise

the gain to ‘make up’ the level as desired. The channel gain can now be set with

adequate headroom to accommodate both loud and quiet signals, and the compressor

can reduce the dynamic range and ‘make up’ any reduction in level. By inserting such a

device into the channel’s insert point you have the ability to remove the guesswork

from setting your system gain.

However, there are still sources of potential problems. The VeniceU is able to operate

at levels up to +21dBu on both the insert send and return. If the maximum input level

of the compressor was less than +21dBu, it is possible to overload the input of the

compressor. The only way to resolve this situation would be to drop the channel input

gain so that the input level of the compressor was not being overloaded. However,

please note that the level returned from the compressor would also be lower

than +21dBu and excessive use of the compressor ‘make up’ gain would

overload the output of the compressor!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Midas VeniceU U24 Seite 98

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info