Bedienungsanleitung Midea RSJ-35 - 300RDN3 (Seite 5 von 22) (Englisch)

684504

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

Installation & Owner's Manual

Prevent water from

flowing backwards

2.1 Unpacking

2.1.1 Accessories

2. BEFORE INSTALLATION

T able . 2-1

Accessory Name Qty. Sharp Purpose

Owner’s & Installation

Manual

Installation and use instruction

This manual

One Way Valve

Drain condensate water

Adaptor

2.2 Location requirements

2.1.2 How to transport

Enough space for installation and maintenance shall be

preserved.

The air inlet and outlet should be free from obstacles and strong

wind.

The base surface should be flat, surface should be inclined no

more than 2° and able to bear the weight of the unit and

suitable for installing the unit without increasing noise or

vibration.

The operation noise and air flow expelled shall not affect

neighbors.

No flammable gas is leaked nearby.

It is convenient for piping and wiring.

If it is installed in indoor space, it might cause indoor

temperature decrease and noise, please take preventive

measures for this.

If the unit has to be installed on a metal part of building, make

sure the well electric insulation which should meet the relevant

local electric standard.

In order to avoid scratch or deformation of the

unit surface, apply guard boards to the

contacting surface.No contact of fingers and

other things with the vanes. Don’t incline the

unit more than 75° in moving, and keep it

vertical when installing.

This unit is heavy, it need to be carried by

two or more persons, othewise might cause injury and damage.

>75°

Gradient limit>75°

The ambient air temperature must also be considered when

installing this unit, in heat pump mode the ambient air

temperature must be above -7℃ and below 43℃.If the ambient

air temperature falls outside these upper and lower limits,the

electrical elements will activate to meet the hot water demand

and the heat pump will not operate.

The unit should be located in an area not subject to freezing

CAUTION

Must be installed.

Separately package.

Install at the air inlet port

Water-proof

Shield

Filter screen

●

If the supply cord is damaged,

it must be replaced by the

manufacturer or its service agent or a similarly qualified person.

●

DISPOSAL:

Do not dispose this product as

unsorted municipal waste. Collection of such

waste separately for special treatment is

necessary. Do not dispose of electrical

appliances as unsorted municipal waste, use

separate collection facilities. Contact your local

government for information regarding the

collection systems available.

●

If electrical appliances are disposed of in landfills or dumps,

hazardous substances can leak into the groundwater and get

into the food chain, damaging your health and well-being.

CAUTION

● The earthing pole of socket must be well grounded, make sure

that power supply socket and plug are dry and connected tightly.

●

Before cleaning, be sure to stop the operation and turn the

breaker off or pull out the power plug. Otherwise, an electric

shock and injury may be caused.

● Water temperature over 50℃ can

cause severe burns instantly or

death from scalds.

Children,

disabled and elderly are at

highest risk of being scalded.

Feel water before bathing or

showering.

Water

temperature

limiting valves are required as

per AS 3500.

● Do not operate the unit with a wet hand. An electric shock may

be caused.

● The installation height of power supply should be over 1.8m, if

there is any water exposure, steps must be taken to separate

the power supply from water.

● A one-way valve must be installed on the water inlet side, as

well as an isolation value.

● It is normal for some water to be released from the PTR valve

during operation. But, if there is a large volume of water, call

your service agent for instructions. After long term use, check

the unit base and fittings. If damaged, the unit may sink, resulting

in injury. Arrange the drain pipe to ensure smooth draining.

Improper drainage work may cause wetting of the building,

furniture etc.

Do not touch the inner parts of the controller or

remove the front panel. Some parts inside are dangerous to

touch, and damage may be caused.

● Do not turn off the power supply.

System will stop or restart heating automatically. A continuous

power supply for water heating is necessary, except service

and maintenance.

Hydrogen gas is extremely flammable, and may build up if no

water is drawn of for several weeks.

To reduce the risk of

injury under these conditions, it is recommended that the hot

water tap is opened for several minutes at the kitchen sink

before using any electrical appliance connected to the hot

water system. When hydrogen is present, there will probably

be an unusual sound such as air escaping through the pipe as

the water begins to flow. There should be no smoking or open

flame near the tap at the time it is open.

NOTE: Water-proof Shield to be purchased by the client, not

along with the product accessories.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Midea RSJ-35 - 300RDN3 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Midea RSJ-35 - 300RDN3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info