Bedienungsanleitung Midea RSJ-35 - 300RDN3 (Seite 21 von 22) (Englisch)

684504

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

Installation & Owner‘s Manual

9. MIDEA– HEAT PUMP MANUFACTUR-

ER’S WARRANTY

This warranty is provided by Midea. It applies to heat pumps installed

in a single family dwelling only and is provided only to those acquiring

the heat pump as consumers within the meaning of the Australian

Consumer Law. The terms of the warranty are effective from the date

the heat pump is installed. Midea may verify this date by requesting a

copy of the compliance certificate that accompanied the installation.

The compliance certificate is mandatory in all Australian states and

territories.

9.1 Warranty period

Midea warrants that the following heat pump components will remain

free of defects for the specified periods from the date of installation:

• Storage Tank- 5 years.

• Compressor- 3 years.

• All other components supplied by Midea, including valves,

elements, thermostats and sacrificial anodes - 1 year.

• Midea gives no warranty in relation to components not supplied by

Midea, for example tempering valves and cold water valve assem-

blies used by installers.

Subject to the conditions and exclusions specified in this warranty,

Midea will at its own expense repair or replace any defective heat

pump component covered by this warranty as soon as reasonably

practicable after the consumer has reported the defect to Midea.

9.2 Consumers must register the warranty

To be eligible to make a claim under this warranty, consumers must

complete all details in the Installation Report & Warranty Registration

form provided with the heat pump within 6 weeks of installation and

send it to the address shown on the form.

9.3 Procedure to make a claim under

warranty

Upon discovering a suspected defect, consumers should immediately

report the suspected defect:

• To the installer or supplier, if the suspected defect arises as a result

of the installation of the heat pump or relates to any components

not covered by this warranty.

• To Midea on the phone number below during the relevant warranty

period, if the suspected defect relates to any components covered

by this warranty.

9.4 Specific exclusions

To the extent permitted by law Midea does not accept liability under

this warranty:

1) If any component of the heat pump has been installed, repaired,

repositioned or modified by a person other than an appropriately

qualified person approved by Midea in accordance with Midea’s

installation and maintenance instructions and relevant local and

statutory requirements;

For loss or damage caused by a fault or defect in the installation

of the heat pump;

If corrosion has occurred because the anode has not been

changed in accordance with the owner’s manual;

4) If a cold water expansion valve, check valve and strainer is not

fitted in areas where mains pressure is likely to exceed 0.65MPa;

5) For any damage arising as a result of an accident, act of God or

other circumstances beyond Midea’s control;

6) If the inner cylinder has collapsed as a result of an incorrect filling

and/or commissioning procedure;

For components not supplied by Midea that are used in the

installation of Midea heat pump water heaters e.g. tempering

valves, cold water valve assemblies, etc.

8) For extended or implied warranties not formally provided by

Midea;

9) For external labour or equipment costs (e.g. cranes and lifting

devices) required for repairs;

10) For costs incurred for rectifying faults (or perceived faults) not

directly attributed to the Midea heat pump water heater;

11) For travel costs of service agents that exceed 30 kilometres;

12) For all consequential loss or damage arising from defects that

can lawfully be excluded;

13) For any other issues not directly attributable to defects in

components supplied by Midea including:

(a) Damage caused by incorrect commissioning;

(b) Leakage from valves not supplied by Midea;

water pressure or temperature exceeds the limits specified in

Midea’s installation and maintenance instructions;

(d) Water hammer;

(e) External rust on the storage tank;

(f) Insufficient hot water because:

(i) The consumer refuses to use the auxiliary booster;

(ii) Of an incorrectly set or faulty tempering or mixing valve;

(iii) Of faulty or incomplete installation;

(iv) The water heater is too small for its required purpose;

(v) Of insufficient water flow as a result of “water saving” tap-ware or

appliances;

(vi) Of blown fuses, “tripped” electrical switches or inadequate

household electrical wiring;

(vii) Insufficient water flow caused by debris accumulating in water

strainer.

9.5 Important note

The benefits conferred by this warranty are in addition to any other

rights and remedies available to the consumer under a law in relation

to the goods or services to which the warranty relates.

Midea’s goods come with guarantees that cannot be excluded under

the Australian Consumer Law. Consumers are entitled to a replace-

ment or refund for a major failure and for compensation for any other

reasonably foreseeable loss or damage. Consumers are also entitled

to have the goods repaired or replaced if the goods fail to be of

acceptable quality and the failure does not amount to a major failure.

Contact Phone: 1300 367 565.

Midea RSJ-35 - 300RDN3 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Midea RSJ-35 - 300RDN3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info