579690
8
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
6
REAR PANEL
9. Antenna connector: PL connector type
10. EXT SPKR jack: external loudspeaker jack.(the internal loudspeaker will
be excluded)
11. Power supply cable: power 12,6V DC
MICROPHONE
1. PTT: transmission button
2. 4 pin microphone connector
INSTALLATION
An extremely important requirement is the ease of installation and removal
for those occasions when you might want to remove the unit for service and
maintenance.
The most common mounting position for a transceiver is under the dashboard
directly over the drive shaft hump. Do not mount the transceiver in the path of
the heater or air conditioning.
Take your time and plan your installation carefully. When you have determi-
ned the best location for mounting, use the mounting bracket as a template to
mark mounting holes. Take care when you drill the holes that you do not drill
into wiring, trim or other accessories.
Mount in position with bolts, lock washers and nuts or self-threading screws.
Insert the power cable with lighter plug into the vehicle’s cigarette lighter cord.
Before operating, you must install and connect your antenna system. The
lead from the antenna you’ve installed should be connected to the antenna
coaxial connector. If you are using an external speaker, connect it to the EXT-
SPKR jack.
INSTALLING AN ANTENNA
A mobile antenna system is not limited to the antenna only. The transmission
line, as well as the vehicle, are important factors in the total antenna system.
Therefore, you must use the correct type of transmission line and mount the
antenna securely in a position that will give you optimal results.
Use coaxial cable with an impedance of 50 Ohms. Generally speaking, you
should keep the length of the transmission line to a minimum.
The above discussion is as important for reception as it is for the transmis-
sion. If a mismatch exists between the antenna and the receiver, the excellent
sensitivity and signal-to-noise radio of the receiver circuit will be defeated.
Useful information
1. Place the antenna as high as possible
2. The longer the antenna is, the better will be the performance
3. Mount the antenna and keep antenna cable away from noise sources,
such as the ignition switch, gauges, etc.
4. Make sure you have a solid metal-to-metal ground connection.
5. Prevent cable damage during antenna installation.
There are many types of mobile CB antennas: a full quarter-wave length
whip, a center loaded whip, top loaded whip and the base loaded type. For
a greater efciency it is recommended 2.5 m long, full quarter-wave whip.
9
CH
19
40
TX
FM AM CHANNEL
SQUELCH ON/OFF VOL
EXT
ANT
SPKR
+
-
RED
BLK
40
RX
SQUELCH ON/OFF VOL
EXT
ANT
SPKR
+
-
RED
BLK
12345
876
10
119
1
2
9
CH
19
40
TX
FM AM CHANNEL
SQUELCH ON/OFF VOL
EXT
ANT
SPKR
+
-
RED
BLK
40
RX
SQUELCH ON/OFF VOL
EXT
ANT
SPKR
+
-
RED
BLK
12345
876
10
119
1
2
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Midland 203 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info