543207
12
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
6
ENGLISH
6
but will not be disturbed by noise on the channel between signals.
When properly set, the Squelch keeps the receiver “dead” until a signal comes in on that
channel. However, do not set the Squelch too high, otherwise weak signals will not be able to
open the Squelch circuit. To receive very weak signals, it is best to leave Squelch set to the mi-
nimum position by rotating the control maximum counterclockwise. The Squelch circuit in your
Transceiver is an advanced design. It uses an operational amp IC to accomplish a hysteresis
action. The result is that when you set the Squelch for a precise signal level, if that signal level
increases or decreases in strength, the Squelch circuit will follow this change. With conventio-
nal Squelch circuit, often a signal which changes strength get “chopped” by the Squelch circuit
and you lose a portion of the message.
With a hysteresis Squelch, you get it all.
To Transmit:
1. Select the desired channel.
2. Press the push-to talk button on the microphone and hold it an angle about 5-7 cm from your
mouth and speak in a normal voice.
3. To receive, release the push-to-talk button.
Be sure the mic plug is rmly connected to the jack.
NOTE: shouting into the mic will not increase your power or signal. An internal circuit automatically
sets the mic signal for maximum modulation, so speaking loudly will give no advantage.
REMOTE SPEAKER OPERATION
A 4 Ohm speaker, rated at 3-10 watts, should be used for this function. Plug the speaker into the
EXT SPKR jack at the rear of the transceiver. When the external speaker is plugged in, the internal
speaker is disconnected. You can now monitor all incoming signals through your remote speaker.
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Midland ALAN 100 PLUS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info