Advice for installation
been programmed for its activation, as per the following instructions.
If it has not been programmed, the command described below will
not be accessible.
1) Press the
button to access the command menu, then press
the
buttons repeatedly until the Lcd&Keypad menu is
highlighted.
2) Press the
again to view the available sub-menus.
3) Press the
or button repeatedly until the Keypad Micr.
sub-menu is highlighted, then press
to conrm. A will ap-
pear beside the sub-menu to indicate that the keypad microphone
is active.
4) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
This procedure should be followed the first time you use your
microphone. If you are using the standard microphone, ensure
the
is disabled by following the above procedure.
To connect/disconnect the MK06/35-K keypad microphone, follow
the same procedure as described for the standard microphone.
5.3.d External speaker (optional)
If you possess an external speaker, connect it to the Input/Output
[10] connector found on the rear panel of the device, referring to
Chapt. 13 and to the instructions supplied with the speaker itself. The
external speaker must be 8 Ohm and able to support a minimum of
12 W of power.
The output of the external speaker is grounded. Be careful not
to create short-circuits with the body of the vehicle.
The transceiver can be programmed so the external speaker
is excluded and only the internal one is used. For further de-
tails, refer to par. 8.4.
