your dealer as to which cable is best suited to
your needs.
To communicate via the attached radio, press
the transmission Press To Talk (PTT) button to
speak and release it to listen. It is not possible to
talk and listen simultaneously. Communications
can be activated also without pushing the PTT
button, by enabling the VOX function.
Special congurations
Some Midland BTSKI features can be
congured to suit specic needs
Voice enable Intercom (VOX) ›
Adjust the microphone sensitivity ›
Disable the VOX feature ›
Wired connection always on ›
Enabling the intercom by voice (VOX)
The Intercom feature can be enabled both
manually and vocally (VOX). The VOX
activation is inuenced by the background
noise and therefore by the speed.
For optimum results, it is possible to choose
one of the following four microphone sensitivity
levels: high, medium, low and very low. The
default setting of BTSKI is “medium”. It is also
possible to disable the VOX feature in order to
activate the Intercom and phone call answering
features in manual mode only.
Adjusting the sensitivity of the
microphone (VOX)
1. Enter the Setup mode: Switch your BTSKI off.
Press and hold down the central button (Con-
trol) until the red indicator switches on perma-
nently. Your BTSKI is now in “Set up mode”.
2. Press the “Volume+” and “Control” buttons till
the red indicator will turn to steady blue.
3. Now, press “Volume +” or “Volume -“to increa-
se or reduce sensitivity. Every time you press
the Volume buttons the RED light will ash for
conrmation. When you reach the end of the
upper and lower limit, the RED light will not
ash.
4. Double press the “Control” button; the Blue
light will ash several times, in order to let you
know the selected sensitivity:
once = VOX disabled
Twice = very low sensitivity
3 times= low sensitivity
4 times= medium sensitivity
5 times = high sensitivity
Default = medium sensitivity
5. The light indicator is now back to steady RED
(“Set up mode”) and the changes are conr-
med
6. If needed, you can adjust again the sensitivity
repeating the steps from point 2, otherwise
exit the Setting mode by double clicking the
“Control” button. Once the red light turns off,
the blue led starts blinking. Now you can use
your BTSKI.
Disabling the VOX feature (Intercom
and telephone)
Follow all the procedure described in the
previous steps and choose the option 1 (VOX
disabled). You will see the blue led blinks once.
