Bedienungsanleitung Miele Professional PT 8337 WP (Seite 28 von 76) (Englisch, Holländisch)

666798

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Cleaning the heat exchanger

Regular and specialist maintenance of the entire

system will maintain the high efficiency of the unit and

help increase the lifespan of its components.

During use, fluff from textiles as well as detergent

residues and other elements present in the

condensed steam collect on the heat exchanger.

Soiling on the heat exchanger reduces heat transfer

to the air and in so doing the efficiency of the unit.

This is why it is important to clean the heat exchanger

regularly. More frequent cleaning may be required

where there is a heavy build-up of fluff or the dryer is

operated very frequently.

A nozzle is supplied for easier cleaning. Attach the

nozzle to a water hose with a 3/4" screw connection.

–

Make sure that the unit is completely

disconnected from the mains electricity supply.

There must be no voltage present.

–

Open the maintenance panel on the back of the

heat pump unit. Place the maintenance panel to

one side safely (danger of injury and tripping over

it).

–

Before starting the rinsing process, take out the

collection tray and remove coarse soiling from it.

This will prevent the drain from becoming blocked.

Ensure that the slats are not bent or damaged.

–

Clean the heat exchanger with a brush in the area

shown in the diagram (see arrows). Replace the

collection tray before you start rinsing.

–

Use a jet of water (max. 4 bar) to rinse the heat

exchanger thoroughly for several minutes. Use the

hose and nozzle to do this.

The use of water is permitted only within the

specific area of the heat exchanger outlined by the

frame in the diagram. The use of pressure washers

or cleaning agents containing chlorine, sand,

sodium carbonate or acid is not permitted.

–

Make sure that you provide adequate drainage for

the water used for cleaning to avoid flooding the

dryer or the room in which it is located.

–

Remove any soiling which has not been rinsed out.

–

Clean the collection tray and check the drain for

any blockages.

–

Make sure the heat exchanger is enclosed by the

maintenance panel before operating the unit again.

–

Make sure that no electrical parts have come into

contact with water before supplying electricity to

the unit again.

–

Avoid touching the slats to protect them from

damage and wear gloves to prevent cuts to your

hands.

Water may be used to clean the heat

exchanger (in the area behind the maintenance

panel) only. Using water to clean the dryer and

other parts is not permitted. Danger to life from

electric shock.

To ensure the correct performance of the

tumble dryer and to prevent the risk of faults and

fire, it is important to check it and carry out

maintenance on a regular basis.

Cleaning and care

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Miele Professional PT 8337 WP Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info