Bedienungsanleitung Minimoka CM-4758 (Seite 27 von 32) (Englisch, Spanisch)

727618

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

least 3 times.

-Clean the opened brewing unit under warm running

water. In particular, the stainless steel screen must be

rinsed out well to remove any coffee residue.

- Shake the brewing unit lightly under water

- Dry the brewing unit.

- Replace the brewing unit by turning it into the right po-

sition (the outlet tube facing downwards and to the front),

insert the brewing unit into the guide grooves and push it

completely into the coffee machine.

Push the coffee grounds container back into the appliance and

push the outlet unit into the upper position. Close the door.

Cleaning the brewing unit:

-It enables intensive cleaning of otherwise inaccessible

areas. The cleaning programme must be started when

the following symbol appears on the display:

-The cleaning process takes approx. 8 minutes and

should not be interrupted.

-In case of power failure during the cleaning programme,

it has to be restarted.

-Before running the cleaning programme, the metal sie-

ves in the brewing unit must be clean and wiped dry.

-The cleaning water is collected in the drip tray.

To run the cleaning programme proceed as follow:

-Press button 2 until the function display “ cleaning

programme” is selected.

-The press OK (button 6).

-Thedisplay“cleaningprogramme”ashesinthedisplay,

whilethe“llwatertank”displayispermanentlylit.

-Removethewatertank(7)andllwithmin1Lfresh

water. Insert the water tank again.

-Open the lid of the coffee bean container (N) and the

coffee power shaft (J).

-Put a cleaning tablet into the coffee powder shaft.

-The press OK (button 6).

The appliance will implement several cleaning cycles.

After the cleaning phase is completed, the OK display

will light up permanently.

- Remove and empty the drip tray.

- Press the drip tray back onto the appliance until it

audibly engages.

-Then push OK (button 6).

-The appliance then initiates the rinsing phase and then

the brewing unit is positioned.

-The cleaning program is complete when the “Cleaning

program” function display goes out.

- Remove the drip tray and empty it.

- Press the drip tray back onto the appliance until it

audibly engages.

-Removethewatertank,llitwithcleanwaterandpush

it back in.

The appliance is now ready for operation again in the

last selected coffee mode status.

Running the descaling programme:

-The descaling program enables simple and effective

descaling of your coffee machine. You should descale

the coffee machine at regular intervals, but at least when

the following symbol appears on the display:

Note:

The descaling process runs in 2 phases, takes approx.

10 minutes and should not be interrupted.

In case of power failure during the descalling program-

me, it has to be restarted.

The frequency of descaling depends on the hardness of

the water in your region. Therefore, please do not forget

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Minimoka CM-4758 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info