2322
FOCUS
USING THE BUILT-IN FLASH
1. Center your subject in the
focus frame, then press the
shutter-release button
partway down.
• appears in the viewfinder when the
focus is confirmed.
• Focus hold also locks the exposure
settings.
2. Continue to hold the shutter-
release button partway down
while you compose your
picture.
3. Press the shutter-release
button the rest of the way
down to take the picture.
• Remove your finger from the shutter-
release button to cancel focus hold.
Use focus hold when your subject is
outside the focus frame or when
autofocus is difficult to confirm.
Focus hold cannot be used for moving subjects.
Focus Hold Flash Signals - (seen in the viewfinder)
Flash is charged.
(Blinks fast)
Flash is charging and the shutter can not be released.
(Blinks slowly)
Previous exposure was correct.
After the picture has been taken.
Flash Range
The range of the built-in flash depends on the speed of the film.
Make sure your subject is within the flash range specified in the
table below.
28-80mm F3.5-5.6 II
LENS IN USE
35-80mm F4-5.6 II
Wide angle Wide angle Telephoto
1.0 ~ 3.4 m
(3.3 ~ 11.2 ft.)
1.0 ~ 6.8 m
(3.3 ~ 22.3 ft.)
1.0 ~ 4.2 m
(3.3 ~13.8 ft.)
1.0 ~ 2.1 m
(3.3 ~ 6.9 ft)
1.0 ~ 3.0 m
(3.3 ~ 9.8 ft.)
1.0 ~ 2.1 m
(3.3 ~ 6.9 ft.)
1.0 ~ 4.2 m
(3.3 ~13.8 ft.)
1.0 ~ 6.0 m
(3.3 ~19.7 ft.)
TelephotoFilm Speed
ISO 100
ISO 400
Make sure you are at least 1m (3.3 ft.) from your
subject when using the built-in flash.
