13
Movie function
The DD100 can record a video clip of up to 60 seconds in
length. Observe the instructions given below to use the mo-
vie function.
1. Switch on the DD100 by pressing the Power On/Off button.
2. Operate the Mode button once to access video mode.The
white icon "
Ⅵ
" (Stop) appears on the monitor (TFT).
3. Frame your subject in the viewfinder.
4. Press the shutter release to start the recording. As soon
as recording starts you will see the red icon "
ⅷ
" (Record).
5. Using the
ᮡ
/T button (up) and the
ᮢ
/W button (down)
you can zoom the image in and out.
6. Press the shutter release button again to end the recording.
Note:
The video mode has a resolution of 320 x 240 MP.
Note:
We recommend leaving the default setting of the white
balance on "Auto".
Setting the exposure correction (EV)
The exposure is automatically controlled by the camera. In
difficult light situations or to achieve special effects you can
correct the exposure manually. Observe the following in-
structions to set the exposure correction (EV).
1. Switch on the DD100 by pressing the Power On/Off button.
You are now in shooting mode.
2. Press the OK/Menu button to access the main menu.
3. Using the
ᮡ
/T button (up) and the
ᮢ
/W button (down)
you can move around the menu selection. Select the fun-
ction "EV" and confirm with the OK/Menu button.
4. Increase the EV value with the
ᮡ
/T button (up) or reduce
the EV value with the
ᮢ
/W button (down).
5. Confirm the desired EV correction by pressing the OK/
Menu button.A beep signal confirms the change.
6. Should you wish to change the EV correction permanently
you must verify the change in the setup mode under
"Setting".
Note:
We recommend leaving the exposure correction on "0".
