Bedienungsanleitung Minox DTC 700 (Seite 28 von 60) (Deutsch, Englisch, Französisch)

625816

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

is on the left next to the movement sensor (5):

On the bottom left is the main switch with three

switching positions (11):

1. 1st function “OFF“: main switch is switched

to the lower position

2. 2nd function “SETUP“: main switch in

middle position

3. 3rd function “ON“: main switch is switched

to the upper position

On the right outer side of the camera core is the

memory card slot (7). In the centre of the camera

core is a 2“ LCD monitor (6). In the upper area of

the camera core there is the camera lens (2), sur-

rounded by the IR LEDs (1) with a black ﬁlter for

night shots.

Turn the camera core around to access the battery

compartment (14) for 8 x 1.5 volt AA batteries. On

the underside of the camera core there are additio-

nal connections for:

- External power source (12)

- USB cable (13) to connect the camera to a

computer (described in the point on

„Connecting the camera to a computer”).

To close the camera, proceed as follows:

1. Replace the camera core in the camera case.

2. Place your DTC 700 in front of you.

3. Snap the camera case shut.

Close the lock (15) on the camera case.

Inserting the batteries

Your DTC 700 camera is designed for alkaline, lit-

hium or nickel-metal hydride (NiMH) AA batteries.

To insert the batteries, open the camera case as de-

scribed above and remove the camera core. Insert

10 x 1.5 Volt AA batteries as instructed in the bat-

tery compartment (14) on the back of the camera

core. Pay attention to the correct insertion direction/

polarity (+/-).

Checking the battery level

Switch your DTC 700 to the “SETUP” mode (control

switch (11) centre). The battery status will be indica-

ted on the bottom left edge of the LCD monitor (6).

Using the memory card

You need a memory card (SD/SDHC-card) in order

to store images or video clips. Your DTC 700 camera

supports memory cards of up to 32 GB.

Inserting the memory card

Open the camera case. Insert the memory card in

the memory card slot (7). Ensure that the gold-co-

loured contacts are visible when you look at the ca-

mera. Ensure that the SD card is not write-protected

(SD cards slider is not in the “lock” mode).

Switch your DTC 700 to “SETUP” mode (main

switch “centre”). When your DTC 700 camera gives

off a beep that means that either no memory card

has been inserted, it was not correctly inserted or

it is not compatible. The LCD monitor will display

a “No card” message in red. If no beeping signal

is sounded, you can continue to adjust the camera.

Note: We recommend using high efﬁciency

batteries for optimum performance. You can

prolong battery life if you create shorter video

sequences.

Note: The external power source can be acces-

sed with 6V. The batteries are bridged when the

camera is connected to an external power sour-

ce. In other words, the battery cannot be char-

ged inside the camera, not even using a solar

panel. Please do not use a power source above

6V as that would damage the camera. In such a

case, you have no claim under guarantee.

Note: If the SD card was used to store data in

other devices, reformat the SD card on a PC. By

reformatting it all all old data will be deleted

from the SD card to ensure error- free functio-

ning. If the SD card was only used in the DTC

700, it can be formatted in DTC 700. Once it is

inserted, the SD card must be checked for proper

functioning by taking pictures.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Minox DTC 700 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info