Bedienungsanleitung Mitsubishi EX321U-ST (Seite 38 von 59) (Englisch)

493681

Zoom out

Zoom in

Vorherige Seite

1/59

Nächste Seite

EN-38

iv. Once set, access to the remote network operation page on this projector has been password-protected.

To enable this function, check the box in front of "Enable" and type in your desired password in the

New Password column and confirm the new password by re-entering the new password at the Confirm

column. To disable password protection, uncheck the box.

v. Once set, access to the Tools page has been password-protected. Refer to step iv for how to use the

password function.

• After making the adjustments, press the Send button and the data will be saved in the projector.

• Once the password is set, the Log Out button will display beside the Tools button.

• Write down your selected password in advance or right after the password is entered so that it is available to you should

you ever forget it. If you forget the password, you will not be able to log in.

• The software is available in English language.

• When DHCP is turned on, there is a possibility of stopping the webpage connection. If this happens, please check the new

IP address of the projector and enter the new address to connect again.

vi. Press Exit to go back to the remote network operation page.

4. The Info page displays the information and status of this projector.

i. The information you entered in the Tools page will display here and these columns are empty when

you use e-Control™ for the first time.

ii. When the projector is in abnormal conditions, the following information will display.

When the projector is in normal conditions or in any abnormal conditions other than the ones mentioned below, the Error

Status column will be empty.

(3 = Error; 1 = notice)

iii. Press Exit to go back to the remote network operation page.

5. After pressing the button ‘Contact IT Help’, the HELP DESK window will appear at the upper right corner. You

will be able to deliver messages to RoomView™ software which is connected to the same local area network.

For more information, visit http://www.crestron.com & www.crestron.com/getroomview.

Controlling the projector using PJLink™ application

This projector supports standard protocol PJLink™ for projector control and you can control and monitor projector's

operations using the same application among projectors of different models and different manufacturers.

About PJLink™

• To use PJLink™ function, the PJLink™ application software is required.

Error Status Description

3: Lamp fail The lamp fails to ignite or turns off during operation.

3: Over Temp The projector temperature is too high or cannot be detected.

3: Fan Lock The fan rotation speed cannot be set or detected.

1: Over Lamp Usage time The lamp is still in use after the lamp warning messages display.

iii

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi EX321U-ST Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info