Bedienungsanleitung Mitsubishi Lancer - 2014 (Seite 125 von 434) (Englisch)

617123

125

Zoom out

Zoom in

Vorherige Seite

1/434

Nächste Seite

Starting and stopping the engine

5-58 Features and controls

6. On vehicles with manual transaxle, place

the gearshift lever in the “N” (Neutral)

position.

On vehicles with continuously variable

transmission (CVT) or Twin Clutch SST,

make sure the selector lever (CVT) or

gearshift lever (Twin Clutch SST) is in the

“P” (PARK) position.

7. Turn the ignition switch to the “ON” posi-

tion and make certain that all warning

lights are functioning properly before

starting the engine.

8. Turn the ignition switch to the “START”

position without pressing the accelerator

pedal. Release the key when the engine

starts.

After several attempts, you may experience

that the engine still does not start.

1. Make sure that all electric devices, such

as lights, air conditioning blower and rear

window defogger, are turned off.

2. While depressing the brake pedal on vehi-

cles equipped with continuously variable

transmission (CVT) or Twin Clutch SST

or the clutch pedal on the vehicles

equipped with manual transaxle, press the

accelerator pedal halfway and hold it

there, then crank the engine. Release the

accelerator pedal, immediately after the

engine starts.

3. If the engine still will not start, the engine

could be flooded with too much gasoline.

While depressing the brake pedal on vehi-

cles equipped with CVT or Twin Clutch

SST or the clutch pedal on the vehicles

equipped with manual transaxle, push the

accelerator pedal all the way down and

hold it there, then crank the engine for 5

to 6 seconds. Return the ignition switch to

the “LOCK” position and release the

accelerator pedal. Wait a few seconds, and

then crank the engine again for 5 to 6 sec-

onds while depressing the brake pedal or

the clutch pedal, but do not push the

accelerator pedal. Release the ignition key

if the engine starts. If the engine fails to

start, repeat these procedures. If the

engine still will not start, contact your

local Mitsubishi Motors dealer or a repair

facility of your choice for assistance.

When the ambient temperature is -4 °F (-20

°C) or lower on vehicles with CVT, or -22 °F

(-30 °C) or lower on vehicles with Twin

Clutch SST, it may not be possible to start

NOTE

 On vehicles with CVT, the starter will not

operate unless the selector lever is in the “P”

(PARK) or “N” (NEUTRAL) position.

On vehicles with Twin Clutch SST, the

starter will not operate unless the gearshift

lever is in the “P” (PARK) position or the

gearshift lever is in the “N” (NEUTRAL)

position with the brake pedal depressed.

For safety reasons, start the engine in the “P”

(PARK) position so that the wheels are

locked.

NOTE

 Minor noises may be heard on engine start-

up. These will disappear as the engine warms

up.

When the engine is hard to start

Startability of continuously vari-

able transmission (CVT) vehicles

or Twin Clutch SST vehicles at

extremely cold ambient tempera-

ture

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi Lancer - 2014 Seite 125

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info