Bedienungsanleitung Mitsubishi Lancer - 2014 (Seite 380 von 434) (Englisch)

617123

380

Zoom out

Zoom in

Vorherige Seite

1/434

Nächste Seite

Tires

Vehicle care and maintenance 9-21

N00939300844

Proper tire inflation pressure is essential for

the safe and satisfactory operation of your

vehicle. The wrong tire pressure will cause

problems in three major areas:

 Safety

Too little pressure increases flexing in the

tire and can cause tire failure. Too much

pressure can cause a tire to lose its ability

to cushion shock. Objects on the road and

potholes could then cause tire damage that

may result in tire failure.

 Economy

The wrong tire pressure can cause uneven

wear patterns in the tire tread. These

abnormal wear patterns will reduce the

tread life, and the tire will have to be

replaced sooner.

Too little pressure also makes it harder for

the tire to roll, and this uses up more fuel.

 Ride comfort and vehicle stability

The superior riding experience built into

your vehicle partly depends on the correct

tire pressure. Too much pressure gives an

uncomfortable and jarring ride. Too little

pressure feels as if your vehicle is slow to

respond.

Unequal tire pressures can make steering

your vehicle uneven and unpredictable.

The correct tire pressure for your vehicle is

listed on the placard attached to the sill of the

driver’s door.

(Refer to “Tire and loading information plac-

ard” on page 11-3.)

The recommended inflation pressures should

be used for the tires listed below.

Tire pressures should be checked, and

adjusted if necessary, at least once a month.

Pressures should be checked more often

whenever weather temperatures change

severely, because tire pressures change with

outdoor temperatures. The pressures listed on

the placard are always “cold inflation pres-

sure”.

Cold inflation pressure is measured after the

vehicle has been parked for at least three

hours or is driven less than 1 mile (1.6 km)

after having been parked for three hours.

Cold inflation pressure must not go above the

maximum values molded into the tire side-

wall. After driving several miles, your tire

inflation pressure may increase 14 to 41 KPA,

2 to 6 PSI from the cold inflation pressure.

Do not let air out of the tires to get back to the

specified cold pressure, or your tire pressure

will be too low.

Check your tires each time you refuel. If one

tire looks lower than the others, check the

pressure for all of them.

You should also take the following safety pre-

cautions:

Tire inflation pressures

Except for vehicles with turbo-

charger

Item Tire size Front Rear

Normal

tire

P205/60

R16

250 KPA,

36 PSI

250 KPA,

36 PSI

P215/45

R18

240 KPA,

35 PSI

240 KPA,

35 PSI

Compact

spare tire

T125/70

D16

T125/90

D16

420 KPA, 60 PSI

Vehicles with turbocharger

Item Tire size Front Rear

Normal

tire

P215/45

R18

215/45R

240 KPA,

35 PSI

240 KPA,

35 PSI

Compact

spare tire

T125/90

D16

420 KPA, 60 PSI

Item Tire size Front Rear

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi Lancer - 2014 Seite 380

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info