Bedienungsanleitung Mitsubishi MSZ-GA35VA (Seite 9 von 15) (Englisch)

599486

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

WHEN THE AIR CONDITIONER IS NOT GOING TO BE

USED FOR A LONG TIME

When it is not going to be used for a long

time:

Perform the FAN operation for 3 or 4 hours

to dry the inside of the air conditioner.

•To perform FAN operation, set the remote controller

to the highest temperature in the MANUAL COOL

mode. (Refer to page 7.)

Turn off the breaker and/or disconnect the

power supply plug.

CAUTION:

Turn off the breaker or disconnect the power supply plug

when the air conditioner is not going to be used for a

long time.

Dirt may collect and this may cause a fire.

Remove the batteries from the remote

controller.

CAUTION:

To prevent liquid leakage, take out all batteries when the

remote controller is not going to be used for a long time.

When the air conditioner is to be used

again:

Clean the air filter and install it in the indoor

unit.

(Refer to page 10 for cleaning instructions.)

Check that the air inlet and outlet of the

indoor/outdoor units are not blocked with any

obstacles.

Check that the earth is connected correctly.

CAUTION:

Earth the unit.

Do not connect the earth to a gas pipe, water pipe,

lightning rod or the earth of a telephone. If the earthing

is incorrect, it may cause an electric shock.

ECONO COOL OPERATION

Use this operation when you want to be comfortable in COOL mode even with energy saved.

TIMER OPERATION (ON/OFF TIMER)

It is convenient to set the timer when you go to bed, when you get home, when you get up, etc.

Perform the following operations while the unit is operating

in the MANUAL COOL mode.

■Press the button.

When the (ECONO COOL) operation is selected in COOL mode, the air

conditioner performs swing operation vertically in various cycle according to

the temperature of air conditioner.

Also SET TEMPERATURE is automatically set 2°C higher than in COOL mode.

To release the ECONO COOL operation:

■Press the button again.

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

•When the button is pressed or the operation mode is changed during

the ECONO COOL operation, ECONO COOL operation is released.

•The

FAN

button, the

TOO

WARM

TOO

COOL

button and ON/OFF timer (explained below)

are available.

What is “ECONO COOL”?

Swing air flow (change of air flow) makes you feel cooler than constant air flow. So, even though the set temperature is

automatically set 2°C higher, it is possible to perform cooling operation with keeping comfort. As a result, energy can be saved.

How to set the ON timer

Press the button during operation.

Each time the button is pressed, the ON timer mode

alternates between ON and OFF.

Set the time of the timer using the TIME

buttons (Forward) and (Backward).

Each time the button is pressed, the set time

increases by 10 minutes; each time the button is

pressed, the set time decreases by 10 minutes.

To release the ON timer:

■Press the button.

How to set the OFF timer

Press the button during operation.

Each time the button is pressed, the OFF timer mode

alternates between ON and OFF.

Set the time of the timer using the TIME

buttons (Forward) and (Backward).

Each time the button is pressed, the set time

increases by 10 minutes; each time the button is

pressed, the set time decreases by 10 minutes.

To release the OFF timer:

■Press the button.

Programming timer operation

The ON timer and the OFF timer can be used in combination. The timer of the set time that is reached first will operate first.

(“ ” mark indicates the order of timer operations.)

•If the current time has not been set, the timer operation cannot be used.

NOTE:

If the main power is turned off or a power failure occurs while AUTO START/STOP timer is active, the timer setting is

cancelled. As these models are equipped with an auto restart function, the air conditioner starts operating with timer

cancelled at the same time that power is restored.

MAINTENANCE

Before starting maintenance

■Turn off the breaker and/or disconnect the

power supply plug.

CAUTION:

When the unit is to be cleaned, switch it off and

disconnect the power supply plug or turn off the breaker.

Since the fan rotates at high speed during operation, it

may cause an injury.

Cleaning the indoor unit

■Clean the unit using a soft dry cloth.

•If the dirt is noticeable, wipe the unit with a cloth

soaked in a solution of mild detergent diluted in

lukewarm water.

•Do not use gasoline, thinner, benzine, polishing

powder, or insecticide. The unit may be damaged.

•The front panel may come off if it is lifted up past its

level position. If the front panel comes off, refer to

step

in CLEANING THE FRONT PANEL.

ECONO COOL

VANE

START

STOP

SG79Y404H03 6/14/06, 10:14 AM9

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi MSZ-GA35VA Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info