Bedienungsanleitung Mitsubishi Outlander Sport - 2014 (Seite 84 von 384) (Englisch)

617119

Zoom out

Zoom in

Vorherige Seite

1/384

Nächste Seite

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)

Features and controls 5-21

Wait a few seconds, and then press the

engine switch to crank the engine again

while depressing the brake pedal (CVT)

or the clutch pedal (manual transaxle), but

do not push the accelerator pedal. If the

engine fails to start, repeat these proce-

dures. If the engine still will not start, con-

tact your local Mitsubishi Motors dealer

or a repair facility of your choice for

assistance.

Startability of continuously variable trans-

mission (CVT) vehicles with an ambient

temperature of -22 °F (-30 °C) or lower

When the ambient temperature is -22 °F (-30

°C) or lower, it may not be possible to start

from a standstill even with the selector lever

in the “D” (DRIVE) position.

This phenomenon occurs because the trans-

axle has not warmed up sufficiently; it does

not indicate a problem. If this occurs, place

the selector lever in the “P” (PARK) position

and let the engine idle for at least 10 minutes.

The transaxle will warm up, and you will be

able to start normally.

Do not leave the vehicle during warm-up

operation.

N00568200014

1. Stop the vehicle.

2. Fully engage the parking brake while

depressing the brake pedal.

3. On vehicles with a manual transaxle,

press the engine switch to stop the engine,

and then move the gearshift lever to the

1st (on a uphill) or “R” (Reverse) (on a

downhill) position.

On vehicles equipped with continuously

variable transmission (CVT), move the

selector lever to the “P” (PARK) position,

and then press the engine switch to stop

the engine.

N00568300028

Insert the F.A.S.T.-key into the key slot in the

glove box. Starting the engine and changing

the operation mode should be now possible.

Remove the F.A.S.T.-key from the key slot

after starting the engine or changing the oper-

ation mode.

Stopping the engine

WARNING

 Do not operate the engine switch while

driving except in an emergency. If the

engine is stopped while driving, the brake

servomechanism will cease to function and

braking efficiency will deteriorate. Also,

the power steering system will not func-

tion and it will require greater manual

effort to operate the steering. This could

result in a serious accident.

NOTE

 If you have to bring the engine to an emer-

gency stop while driving, press and hold the

engine switch for 3 seconds or more, or press

it quickly 3 times or more. The engine will

stop and the operation mode will go to ACC.

 On vehicles equipped with continuously

variable transmission (CVT), do not stop the

engine with the selector lever in any position

other than the “P” (PARK) position. If the

engine is stopped with the selector lever in

any position other than the “P” (PARK) posi-

tion, the operation mode will go to ACC

rather than OFF.

Put the operation mode in OFF after placing

the selector lever in the “P” (PARK) posi-

tion.

If the F.A.S.T.-key is not operat-

ing properly

BK0202700US.book 21 ページ２０１３年３月２８日　木曜日　午前１１時５４分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi Outlander Sport - 2014 Seite 84

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info