Bedienungsanleitung Mitsubishi Outlander Sport - 2014 (Seite 109 von 384) (Englisch)

617119

109

Zoom out

Zoom in

Vorherige Seite

1/384

Nächste Seite

Starting the engine

5-46 Features and controls

 Do not operate the starter motor continu-

ously for longer than 15 seconds as this

could run the battery down or damage the

starter motor. If the engine does not start,

turn the ignition switch back to the “OFF”

position, wait a few seconds, and then try

again. Trying repeatedly with the engine

or starter motor still turning will damage

the starter mechanism.

 If the engine will not start because the bat-

tery is weak or discharged, refer to

“Jump-starting the engine” (on page 8-2)

for instructions.

 A longer warm up period will only con-

sume extra fuel. The engine is warmed up

enough for driving when the bar graph of

engine coolant temperature display starts

to move. Refer to “Interrupt display

screen (With ignition switch or operation

mode in ON)” on page 5-92.

This model is equipped with an electronically

controlled fuel injection system. This is a sys-

tem that automatically controls fuel injection.

There is usually no need to depress the accel-

erator pedal when starting the engine.

The starter should not be run for more than 15

seconds at a time.

To prevent battery drain, wait a few seconds

between attempts to restart the engine.

1. Make sure all occupants are properly

seated with seat belts fastened.

2. Insert the ignition key.

3. Make sure the parking brake is applied.

4. Press and hold the brake pedal down with

your right foot.

5. Press and hold the clutch pedal all the way

down (manual transaxle).

6. On vehicles equipped with manual trans-

axle, place the gearshift lever in the “N”

(Neutral) position.

On vehicles equipped with continuously

variable transmission (CVT), make sure

the selector lever is in the “P” (PARK)

position.

7. Turn the ignition switch to the “ON” posi-

tion and make certain that all warning

lights are functioning properly before

starting the engine.

8. Turn the ignition switch to the “START”

position without pressing the accelerator

pedal. Release the key when the engine

starts.

Tips for starting

WARNING

 Never run the engine in a closed or poorly

ventilated area any longer than is needed

to move your vehicle out of the area. Car-

bon monoxide gas, which is odorless and

extremely poisonous, could build up and

cause serious injury or death.

CAUTION

 Do not push-start the vehicle.

 Do not run the engine at high rpms or drive

at high speeds until the engine has had a

chance to warm up.

 Release the ignition switch as soon as the

engine starts. Otherwise, the starter motor

will be damaged.

Starting the engine

NOTE

 On vehicles equipped with CVT, the starter

will not operate unless the selector lever is in

the “P” (PARK) or “N” (NEUTRAL) posi-

tion.

For safety reasons, start the engine in the “P”

(PARK) position so that the wheels are

locked.

NOTE

 Minor noises may be heard on engine start-

up. These will disappear as the engine warms

up.

BK0202700US.book 46 ページ２０１３年３月２８日　木曜日　午前１１時５４分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi Outlander Sport - 2014 Seite 109

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info