Bedienungsanleitung Mitsubishi Outlander Sport - 2014 (Seite 141 von 384) (Englisch)

617119

141

Zoom out

Zoom in

Vorherige Seite

1/384

Nächste Seite

Tire pressure monitoring system

5-78 Features and controls

The tire pressure monitoring system may not

work normally in the following circum-

stances:

 A wireless facility or device using the

same frequency is near the vehicle.

 Snow or ice is stuck inside the fenders

and/or on the wheels.

 The tire inflation pressure sensor’s battery

is dead.

 Wheels other than Mitsubishi genuine

wheels are being used.

 Wheels that are not fitted with tire infla-

tion pressure sensors are being used.

 Wheels whose ID codes are not memo-

rized by the vehicle are used.

 Compact spare tire is fitted on a road

wheel.

 A window tint that affects the radio wave

signals is installed.

N00532901192

If new wheels with new tire inflation pressure

sensors are installed, their ID codes must be

programmed into the tire pressure monitoring

system. Have the tire and wheel replacement

performed by an authorized Mitsubishi

Motors dealer to avoid the risk of damaging

the tire inflation pressure sensors. If the

wheel replacement is not done by an autho-

rized Mitsubishi Motors dealer, it is not cov-

ered by your warranty.

N00533001246

Your tire pressure monitoring system oper-

ates on a radio frequency subject to Federal

Communications Commission (FCC) Rules

(For vehicles sold in U.S.A.) and Industry

Canada Rules (For vehicles sold in Canada).

This device complies with part 15 of FCC

Rules and Industry Canada licence-exempt

RSS standard(s).

Operation is subject to the following two con-

ditions.

 This device may not cause harmful inter-

ference.

 This device must accept any interference

received, including interference that may

cause undesired operation.

CAUTION

 If a tire has a puncture, replace that tire with

the spare tire. Driving on a punctured tire

could lead to an accident.

 The warning light/display may not illuminate

immediately in the event of a tire blowout or

rapid leak.

NOTE

 To avoid the risk of damage to the tire infla-

tion pressure sensors, have any punctured

tire repaired by an authorized Mitsubishi

Motors dealer. If the tire repair is not done by

an authorized Mitsubishi Motors dealer, it is

not covered by your warranty.

 Do not use an aerosol puncture-repair spray

on any tire.

Such a spray could damage the tire inflation

pressure sensors.

Have any puncture repaired by an authorized

Mitsubishi Motors dealer.

NOTE

 Tire inflation pressures vary with the ambi-

ent temperature. If the vehicle is subjected to

large variations in ambient temperature, the

tire inflation pressures may be under-inflated

(causing the warning light/display to come

on) when the ambient temperature is rela-

tively low. If the warning light/display

comes on, adjust the tire inflation pressure.

Whenever the tires and wheels

are replaced with new ones

CAUTION

 The use of non-genuine wheels will prevent

the proper fit of the tire inflation pressure

sensors, resulting air leakage or damage of

the sensors.

General information

BK0202700US.book 78 ページ２０１３年３月２８日　木曜日　午前１１時５４分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi Outlander Sport - 2014 Seite 141

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info