Bedienungsanleitung Mitsubishi Outlander Sport - 2014 (Seite 153 von 384) (Englisch)

617119

153

Zoom out

Zoom in

Vorherige Seite

1/384

Nächste Seite

Multi-information display

5-90 Features and controls

This displays the average speed from the last

reset to the present.

There are 2 types of mode settings as follows.

For details on how to change the average

speed display setting, refer to “Changing the

function settings (With ignition switch or

operation mode in ON)” on page 5-96.

 When the average speed is being dis-

played, if you hold down the multi-infor-

mation meter switch, these calculations

will be reset to zero.

 When the following operation is per-

formed, the mode setting changes auto-

matically from manual to auto.

[Except for vehicles equipped with the

F.A.S.T.-key]

Turn the ignition switch to the “ON” posi-

tion from the “ACC” or “OFF” position.

[For vehicles equipped with the F.A.S.T.-

key]

Change the operation mode to ON from

ACC or OFF.

 When the average speed is being dis-

played, if you hold down the multi-infor-

mation meter switch, these calculations

will be reset to zero.

 When the engine switch or the operation

mode is in the following conditions, the

average speed display will automatically

reset.

[Except for vehicles equipped with the

F.A.S.T.-key]

The ignition switch has been set to the

“ACC” or “OFF” position for about 4

hours or more.

[For vehicles equipped with the F.A.S.T.-

key]

The operation mode has been set to ACC

or OFF for about 4 hours or more.

NOTE

 The driving range is determined based on the

fuel consumption data. This may vary

depending on the driving conditions and hab-

its. Treat the distance displayed as just a

rough guideline.

 When you refuel, the driving range display is

updated.

However, if you only add a small amount of

fuel, the correct value will not be displayed.

Fill to a full tank whenever possible.

 When your vehicle is stopped on an

extremely steep hill, the driving range value

may, change. This is due to the movement of

fuel in the tank and does not indicate any

breakdown.

 The display setting can be changed to the

preferred units (miles or km).

Refer to “Changing the function settings

(With ignition switch or operation mode in

ON)” on page 5-96.

Average speed display

Manual reset mode

Auto reset mode

NOTE

 The average speed display and the average

fuel consumption display can be reset sepa-

rately in both auto reset mode and manual

reset mode.

 “---” is displayed when the average speed

cannot be measured.

 The initial (default) setting is “Auto reset

mode”.

 The display setting can be changed to the

preferred units (mph or km/h).

Refer to “Changing the function settings

(With ignition switch or operation mode in

ON)” on page 5-96.

BK0202700US.book 90 ページ２０１３年３月２８日　木曜日　午前１１時５４分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi Outlander Sport - 2014 Seite 153

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info