Bedienungsanleitung Mitsubishi SRK20ZMX-S (Seite 30 von 34) (Englisch)

604708

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

–29–

Airflow is not blown out for 5 to 15 min. or blown out not

warm wind for a moment at HEATING operation.

RUN light blinks slowly

(1.5 sec ON, 0.5 sec OFF)

Notice

The unit does not restart immediately after you have

stopped it.

(RUN light is on)

Not

operating?

Airflow is not blown out when starting the HEATING opera-

tion.

RUN light blinks slowly

(1.5 sec ON, 0.5 sec OFF)

Airflow has stopped to prevent blowing out of cold air until the

indoor heat exchanger has warmed up. (2 to 5 min.) (HOT

KEEP program)

When outdoor temperature is low and humidity is high, the unit

sometimes performs defrosting automatically. Please wait. Dur-

ing defrosting, water or steam may escape from the outdoor

unit.

Airflow is not blown out when starting the DRY operation.

(RUN light is on)

The indoor fan may stop to prevent re-evaporation of

dehumified moisture and to save energy.

Some steam escapes during COOL operation.

This may occur if the room's temperature and humidity are very

high. It disappears as soon as the temperature and humidity

decrease.

Restart is blocked for 3 minutes after you have stopped the op-

eration to protect the unit.

The three-minute protection timer in the microcomputer auto-

matically starts it up again.

Please wait for

three minutes.

If the unit is operated for a long time in high humidity, moisture

may form on the air outlet grills and start dripping.

You hear a slight gurgling sound.

This is caused by refrigerating liquid moving within the unit.

You hear a slight cracking sound.

This is caused by heat expansion or contraction.

Remote control signals may not be received if the signal

receiver on the air-conditioner is exposed to direct sunlight or

other bright light.

If so, cut out the sunlight or reduce the other light.

After a power cut, the unit does not restart even if power

has been restored.

If the auto restart function is not set, the unit will not restart

automatically. Use the remote control to start the operation

again.

Remote control signals are not received.

Moisture may form on the air outlet grills.

There is a slight smell.

Air blown out during operation may smell. This is caused by

tobacco or cosmetics adhering to the unit.

You hear a hissing or clicking sound.

This is caused by the operation of the refrigerant control valves

or electric components.

The noise means that the revolution speed of the compressor is

increasing or decreasing.

Whistling noise is heard from the outdoor unit.

Indoor fan : Fan will not stop after 2 hours if set to CLEAN

operation.

Outdoor fan : Fan will not stop about a 1 minute period in

order to protect the unit.

Fan will not stop immediately after unit operation was

stopped.

The RUN light illuminates during CLEAN operation.

Run light turns off when CLEAN operation ends.

RUN light stays on even though operation was stopped.

This is the sound when operation of another indoor unit is

stopped.

Sometimes a “Shooooo” sound might come for a short time

from the unit that is turned off.

RKY012A012B_EN_001-032 4/18/14, 16:5029

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi SRK20ZMX-S Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mitsubishi SRK20ZMX-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info