Bedienungsanleitung Mitsubishi SRR25ZM-S (Seite 28 von 32) (Englisch)

604713

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

– 27 –

Contact your dealer

■ Turn off the power switch immediately and inform your dealer in any of the following situations:

The fuse or switch blows continu-

ously.

The cable becomes extremely hot.

The covering of the cable is cracked.

The TV, radio or other equipment

starts to malfunction.

When the foreign matters enter the indoor unit through the

air outlets and the dumper becomes inoperable, call your

dealer.

A switch does not activate properly. You hear a strange noise during

operation.

Fuse often blows.

The RUN and TIMER lights on the unit display section blink

quickly (0.5 sec. ON; 0.5 sec. OFF) and do not work.

CAUTION

If the power cord becomes damaged, ask your dealer or a qualiﬁ ed engineer to

install the replacement to avoid accidents.

About the Multiple Air-conditioner

Simultaneous Operation

Automatic Operation

Refrigerant (oil) recovery operation

• The air-conditioners cannot be in different operating modes at the same time, such as one unit being in the “Cool” mode and one

unit being in the “Heat” mode.

• When conducting different operations, the air-conditioner that was operated ﬁ rst will be given priority, so the air-conditioner that is

operated after that will conduct air blowing operation.

• When you want to give priority to the air-conditioner that was started later, either stop the air-conditioner that has priority or cause

the operation type of the unit operated ﬁ rst to match that of the unit operated second.

• When other indoor units are operating in different modes, the RUN light illuminates.

• When the remote control operation switch is in the “Auto” mode the air-conditioner automatically selects either “Cool,” “Dry,” or “Heat”

when operation is started depending on the room temperature.

• During simultaneous operation of air-conditioner units, operation modes may be automatically changed in response to the tempera-

tures of the individual rooms; this will result in the operation of the outdoor unit being stopped. In such a case, COOL or HEAT mode

should be used instead of AUTO. (This is only relevant when more than one air-conditioner unit is being used.)

• If the all of the indoor units are not operated at the same time for an extended period, the cooling or heating performance may tem-

porarily decrease. This is in order to control the recovery of the refrigerant (oil) in the stopped indoor unit(s). At this time, the sound

of refrigerant ﬂ owing may be heard from the stopped indoor unit(s).

OFF

0.5 sec.

When abnormalities occur, turn off the power source immediately and turn it on after 3 minutes.

Restart the operation with ON/OFF button of the remote control and the abnormalities still continue.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi SRR25ZM-S Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mitsubishi SRR25ZM-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info