Bedienungsanleitung Mitsubishi SRR35ZJ-S (Seite 19 von 24) (Englisch)

604735

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

–18–

Proper installation

Pay attention to operating noises!

• When you install the unit, take care to choose a place that can comfortably stand the weight of the unit and does not increase the operating noise

or vibration. If vibration is transmitted through the house, fix the unit with the aid of vibration-proof pads between the unit and the fittings.

• Select a place where cold or hot air, operation noises from the indoor and outdoor units do not cause any inconvenience to your neighbours.

• Do not leave any obstacles near the outlet and inlet of the outdoor unit. This may cause malfunctioning and increased operating noise.

• If you hear an irregular noise during operation, contact your dealer.

Inspection and maintenance

Depending on operating environment, the inside of the air-conditioner may become dirty after a few year operations. This will reduce

performance. In addition to normal cleaning, we would recommend inspection and maintenance. (This may lead the air-conditioner to having a

longer life without any trouble.)

• Contact your dealer, or any distributor, for inspection and maintenance. (There will be a charge for this service).

• We would recommend inspection and maintenance to be carried out during the off-season.

• If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special

purpose tools are required.

Suitable installation position

• Do not put any obstruction in front of the indoor unit, preventing proper ventilation and functioning.

• Do not install the unit in any of the following places:

• Where there is a danger of leaking flammable gases.

• Where there is substantial splashing of oil.

• Malfunctioning due to corrosion may occur if the unit is installed in a spa where sulfide gases are generated, or in a seaside resort exposed to

sea breezes. Contact your dealer.

• The air-conditioner and remote control must be at least 1 metre away from a TV set or radio.

• Drain the dehumidified liquid from the indoor unit into a spot that drains well.

The air-conditioner does not work at all.

Has the timer been set in the

“ON” position?

Has the power switch been

turned off?

Is there a power failure or a

blown fuse?

Troubleshooting

Please carry out the following checks before making a service call.

Poor cooling

Poor cooling or heating

Did you leave any doors or

windows open?

Have you set the thermostat at a

suitable temperature?

Is there a heat source in the

room?

Are there too many people in

the room?

Is the air filter clean? (Not

clogged?)

suitable

temperature

Is there any direct sunlight en-

tering the room?

If the air-conditioner does not oper-

ate properly after you have checked

the left points, or if any doubt still

exists after you have consulted page

19, or if things happen as shown on

page 20, switch off the power and

contact your dealer.

An alternative refrigerant (R410A) is used in this air-conditioner. When asking your

dealer for service or inspection and maintenance, explain the dealer about it.

RJD012A200G_EN_001-022 4/21/14, 13:4418

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi SRR35ZJ-S Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mitsubishi SRR35ZJ-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info