Bedienungsanleitung Mitsubishi SRR50ZM-S (Seite 24 von 32) (Englisch)

604715

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

– 23 –

SELF CLEAN operation

■ CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside the indoor unit and control the

growth of mold and bacteria.

In order to active CLEAN operation, press the CLEAN

switch with the tip of a ballpoint pen.

Every time the CLEAN switch is pressed, the display is

switched in the order of:

No display

(CLEAN on) (CLEAN off)

NOTE

• Two hours later, the air-conditioner stops CLEAN operation automatically.

To stop the air-conditioner immediately, press the ON/OFF button.

• CLEAN operation is not operated after HEAT, FAN, OFF-TIMER and

SLEEP operations have ﬁ nished.

• The indoor unit fan runs for about two hours in CLEAN operation.

• The RUN light illuminates during CLEAN operation.

• Pressing the SLEEP button or NIGHT SETBACK button during CLEAN

operation cancels the CLEAN operation and then the unit is set to

SLEEP or NIGHT SETBACK operation.

• This is not a function for removing mold, germs or grime that have al-

ready adhered to the unit.

Auto restart function

■ What is auto restart function?

• Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power cut, and then

automatically resumes operations after the power has been restored.

• The following settings will be canceled:

1 Timer settings

2 HIGH POWER operations

• Auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this function needs

to be switched off.

• When power failure occurs, the timer setting is canceled. Once power is resumed, set the timer again.

NOTE

Tips for effective operation

■ Please observe the following for the most economic and comfortable use of your unit.

3 sec.

1 sec.

OFF

Set a suitable room temperature.

Excessively high or low temperatures

are not good for your health and waste

of electricity.

Avoid direct sunlight and draught.

Cut out direct sunlight by drawing the

curtains or blinds when cooling. Keep

windows and doors shut, except when

ventilating.

Operate the unit only when

needed.

Use the timer properly to operate the

unit only when needed.

Clean the ﬁ lters frequently.

Clogged ﬁ lters may block the airﬂ ow and

cause less efﬁ cient operation.

Please request cleaning of the air ﬁ lter

from special contractor.

According to handling directions

of local arrangements part,

adjust the airﬂ ow direction

properly.

Adjust the up/down and left/right airﬂ ow

to ensure a steady room temperature.

Air ﬂ ow direction adjustment can not be

performed by unit.

Keep heat source away when

cooling.

Keep heat sources out of the room as

much as possible.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi SRR50ZM-S Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mitsubishi SRR50ZM-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info