475319
113
Zoom out
Zoom in
Vorherige Seite
1/124
Nächste Seite
Appendices 113
Figure 1.
WARNING
THE GRILLE/COVER IS PROVIDED WITH AN
INTERLOCK TO REDUCE THE RISK OF EXCESSIVE
ULTRAVIOLET RADIATION. DO NOT DEFEAT
ITS PURPOSE OR ATTEMPT TO SERVICE THE
TV WITHOUT REMOVING THE GRILLE/COVER
COMPLETELY.
Appendix H: Lamp Cartridge Replacement, continued
1. Turn TV power off and allow the lamp to cool at least
one hour before proceeding.
2. After the lamp has cooled, remove the plastic air
exhaust grille/cover by removing two screws with a #2
(large) Phillips screwdriver. See figure 1.
3. With a large flat-blade screwdriver, loosen the three
shiny screws securing the lamp cartridge until they
disengage from the mating threads. These are
captive screws and cannot be separated from the
lamp cartridge.
4. Fully open up the bag supplied with the replacement
lamp and set the opened bag aside. If no bag was
supplied, use any available small paper bag.
5. Grasp the wire handle of the lamp cartridge and
pull the old cartridge straight out towards you. See
figures 2 and 3. Note the orientation of the cartridge.
CAUTION: Do not tilt or rotate the cartridge, as small
glass fragments may fall out.
6. Without tilting or putting down the lamp cartridge,
insert it into the opened bag. Close the bag while
being careful that no glass particles fall out.
7. Do not touch the glass parts of the new lamp
cartridge. Insert the new cartridge into the TV in the
same orientation as the old cartridge. Push on the
cartridge housing until it is fully seated.
8. With either your fingers or the screwdriver, gently
tighten the three screws. If using a screwdriver,
use only two fingers for final tightening. AVOID
OVERTIGHTENING!
9. Replace the plastic grille/cover and retaining screws.
10. WASH YOUR HANDS THOROUGHLY, AS THIS LAMP
CONTAINS MERCURY.
11. Contact your local authorities or the Electronic
Industries Alliance at www.eiae.com for
lamp-disposal or recycling instructions. Do not
dispose of the old lamp with common trash.
12. Reset the Lamp Reminder from the TV Setup menu
as follows:
a. Press TV MENU to open the Setup menu.
b. Move the highlight to Lamp Reminder.
c. Press ENTER twice.
Figure 3.
Handle
Figure 2.
113

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mitsubishi WD-62628 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info