Bedienungsanleitung Mitsubishi WS55515 (Seite 22 von 100) (Englisch)

32991

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Connecting the IR Emitter NetCommand

IR EMITTER

NetCommand

TV back panel

(section detail)

A/V Receiver

Other A/V device

Figure 13. Connecting IR Emitter NetCommand

IR Emitter NetCommand

Figure 13

A quadruple IR Emitter cable is included with the TV.

The emitters connected to these jacks are used by the

NetCommand system to control other devices such as

VCR, DVD players, Cable boxes and Satellite receivers.

1. Connect the plug end of the supplied quadruple IR

Emitter Cable to one of the IR Output NetCommand

jacks on the TV back panel.

2. Run the cable for each of the emitter ends under,

along side or over the top of each device to be

controlled to the area of the front where the remote

control sensor is located.

3. Place the emitter end in front of the remote control

sensor of the device to be controlled. The emitter

bulb should face the remote control sensor. This

bulb emits infrared light in a cone shaped pattern.

The bulb needs to be placed far enough from the

remote control sensor to allow the cone pattern to

include the sensor.

The remote control sensor is usually behind the plastic

window of the front display panel. It is sometimes

visible when you look through the display plastic using

a flashlight and is normally a round or square cutout

behind the plastic. If you cannot see the sensor and

the device’s Owner’s Guide does not specify the

If a single emitter end can be placed in a

position that will operate more than one device,

do not use a separate emitter end for the

additional device. A single device receiving

remote control signals from too many emitters

or remote controls may not respond at all.

IMPORTANT

location, you can find it by using the device’s remote

control. Hold the remote about 1/2 inch from the front

of the device. Starting from one end of the display

window plastic, press the POWER button.

If the device does not respond, move the remote

control 1 inch toward the center and try again. Repeat

this until the device responds. Note this location then

start over from the other end of the display window

plastic, repeating until the device responds again. The

remote control sensor will be somewhere between

these two positions. This is usually enough accuracy

for the placement of the IR emitters.

4. With some devices, the emitter will work better

facing downward from the top of the device. Some

experimentation may be needed. If you are not

going to

be using all emitter ends, place the unused

ends behind the devices so that they cannot send

signals to the remote control sensors.

5. The emitter end being used can be secured in place

using double stick tape.

6. Place any unused emitters in an out-of-the-way

location.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi WS55515 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info