25
7.2 HOW TO ACTIVATE THE CML4275
After the previous steps the Mobeye CML4275 is ready for use. It is armed
automatically.
In order to switch off (disarm) the CML4275:
- Press the button for 1 second. The green
LED switches off to indicate the
disarmed status.
In the disarmed status the Mobeye
CML4275 will not send alarm
notifications. The unit remains active and
is able to switch on time-controlled and
to send 'low battery voltage' messages.
In order to switch on (arm) the Mobeye CML4275:
- Press the button for 1 second. The green LED blinks once every 3
seconds (battery-powered) or stays on continuously (in case of an
external power supply).
If powered externally (with network connection), switching can be done via
SMS commands:
SMS command to switch on: CODE ARM (e.g. 1111 ARM)
SMS command to switch off: CODE DISARM (e.g. 1111 DISARM)
7.3 SYSTEM RESET
To reset the Mobeye CML4275 to its factory settings:
1. Remove the batteries and SIM card (and external power supply).
2. Press the outside button while reinserting the batteries. Keep it pressed
for (about) another 5 seconds.
3. Release the button immediately after the LED starts to flash.
After a successful reset, the status LED will blink green to indicate that the
module is not configured. The security code is back to factory settings as
well.
