13
4.5 HOW TO ACTIVATE THE OUTDOOR ALARM
In order to switch on (arm) the Mobeye Outdoor Alarm:
- Hold a tag briefly against the tag reader, after which
the exit indication starts. The exit time takes 120
seconds; hereinafter the sensor is active. In the first 20
seconds, the red LED in the sensor flashes.
In order to switch off (disarm) the Mobeye Outdoor Alarm:
- Hold a tag briefly against the tag reader. A short beeps are heard to
indicate a correct disarming. After a few (max. 15) seconds three beeps
sound which indicates that the system has fully completed the disarming
process.
In the disarmed status the Mobeye Outdoor Alarm will not send alarm
notifications. The unit remains active and is able to switch on time-
controlled and to send test and 'low battery voltage' messages.
4.6 SYSTEM RESET
To reset the Outdoor Alarm two steps are necessary, in following sequence:
1. Delete the Mobeye Outdoor Alarm from the Mobeye Internet Portal
Go to "Device Settings" and click on the delete icon in the "Device" block.
Then confirm your choice.
2. Reset the Mobeye Outdoor Alarm to its factory settings
1. Remove / disconnect the batteries.
2. Keep (an enrolled) tag against the outside button while reinserting the
batteries. Keep it pressed for (about) another 5 seconds.
3. Release the tag immediately after the LED starts to flash.
4. If relevant, connect the battery pack.
5. Re-enroll the tags (see chapter 6).
After a successful reset, the outside LED will blink green to indicate that the
module is not configured.
The SIM card is now disconnected and is visible on the "Add device" screen.
The SIM card can be used again in another (or the same) Mobeye device in
combination with the portal.
