17
6. ENROLMENT OF NEW TAGS
Tags are used for switching on and off and to enter the program mode. The
supplied tags are already enrolled and therefore ready-to-use. If additional
tags are provided, they must be enrolled by the user. To enrol a new tag,
the device should be in program mode (see 3.5). Once in program mode,
send following SMS command to the device’s phone number to reach the
enrolment mode:
SMS command to switch to the tag enrolment mode:
CODE TAG
example: 1111 TAG
mind the space between the installation code and TAG
A short melody confirms the correct command and indicates the tag
enrolment mode. The tag reader turns red (for 15 seconds).
Now hold a new tag to the tag reader at the bottom of the detector. The
detector confirms the successful enrolment of the new tag by beeps. The
number of beeps represents the tag number (the first tag beeps once, the
second tag twice, etc.). If a tag was enrolled before, the beeps will sound to
indicate the tag number; it will not re-enrol.
The detector leaves the enrolment mode if no tag was hold against the tag
reader for 15 seconds.
In total 25 tags can be enrolled to the CMVXI-R. The same tags will function
in combination with other CMVXI-R Outdoor Alarm systems, which makes it
possible to operate several devices with one tag.
To delete a certain tag, first check the memory position by the enrolment
procedure. Once in program mode, send following SMS command to the
telephone number in the device to delete a tag:
SMS command to delete tag x (replace x by your number):
CODE DELTAG3
example: 1111 DELTAG3
mind the space between the code and TAG
