5
Save/Recall
Press the button to recall a previously saved setting (i.e. Preset). Press and
hold down the button to save the current set-up.
Back
Press to return to a previous menu item/function.
Infra-red sensor
Receives IR commands from the supplied remote control. A clear
unobstructed line of sight between the remote control and the sensor is
required.
Clip
Flashes when the input to the subwoofer DSP circuitry starts to clip or
overdrive which will degrade the sound and more importantly could
damage the subwoofer/bass drivers. If this happens turn the volume down
on your connected receiver/ amplifier, rather than or the subwoofer itself,
this reduces the level at the subwoofer input rather than the output level.
4. Top panel controls
1
1
2
3
4
5
6
7
2
3
4
5. Display
Notch/Boost filter 1 and 2 active.
Numeric display for volume etc.
Text display.
Refer to later sections of this manual for more information about these
adjustments and functions.
1
2
3
3
15
4
2
6
Power
Lights up bright when the subwoofer is switched "On" and dim when in
standby mode.
Selector
Rotate the dial to cycle through the menu item/function.
Enter
Press to accept the item/function highlighted in the display menu. Also
press to turn "On" when in standby mode and press and hold to put into
standby mode.
5
6
7
Units for numeric value.
Low pass slope.
Phase filter active.
4
5
6
