5
www.morphyrichards.com
I
f you turn the control dial down
f
rom a hot setting to a cooler
setting, wait until the iron
temperature has stabilised before
y
ou continue ironing.
Filling
A
1 M
ake sure that the iron is not
plugged in and then set the variable
steam control
‹ to the ‘0’ position
before filling the iron with water.
2 Lift up the fill cap and fill the water
through the filling hole
› into the
water tank
·, using the beaker
provided A. After filling replace the
fill cap. In hard water areas the use
of distilled or demineralised water is
recommended.
WARNING: Never use battery
topping up fluid or water
containing any substances like
starch, or sugar, or defrosted
water from a refridgerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your iron
with tap water always use the
beaker provided. Never fill
directly under the tap.
Tank capacity
Models 40701 - 400ml
Model 40707 and 40711 - 350ml
Temperature control
Plug in the iron and switch on. Set
the temperature control dial
B to
the temperature required, but don’t
start ironing immediately.
If you wait a few minutes, the iron
will stabilise at the required setting.
Your Morphy Richards iron is fitted
with an indicator light
„ which will
go on and off while you are ironing.
This is perfectly normal as it shows
that the iron is maintaining the heat
setting you have chosen.
It is always a good idea to begin
with cool fabrics and work up to
higher settings.
An iron heats up quicker than it
cools down so you’ll save time and
electricity.
F
eatures of your iron
Temperature indicator light
The indicator light shows that the
i
ron is warming up. When the
r
equired temperature is reached the
light will go out and will cycle on-off
during operation.
D
ry ironing
You can use your iron as a dry iron
only. Make sure the variable steam
control
‹ is set to the ‘0’ symbol.
Any temperature setting may be
used depending on the garment.
The spray feature may be used
provided there is water in the tank
(see filling section). You do not need
to put any water in the tank when
dry ironing only.
Spray
Press the spray button ⁄ and aim
the spray of water at stubborn
creases. You can do this whilst dry
ironing providing there is water in
the tank. When using the water
spray it may be necessary to push
the button a few times to get the
spray pump primed.
Variable steam
Fill the iron with water as described
in ‘Filling’, page 4 and insert the
plug into the electrical socket.
The steam output can be varied
from low to high by turning the
variable steam control
C. When
using the iron at 2-Dot, the steam
output should be adjusted to the
low setting.
The steam facility should only be
used on garments which are
suitable for ironing at 2 and 3 dot
setting.
Shot of steam
Press the shot of steam button ¤
to obtain a burst of extra steam for
ironing out creases in heavy
material such as denim etc.
The shot of steam can be used
whilst dry ironing, providing there is
water in the tank, and the
temperatur
e control is set within the
steam range.
Do not use shot of steam at
temperatures below the steam
range shown on the contr
ol dial.
g
C
Lower steam
Higher steam
