Bedienungsanleitung Morso 1452 (Seite 8 von 16) (Englisch)

744379

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

ENG

2.0 Firing the stove/Using your stove

The heat output of your stove is regulated by means of the air inlets. The primary air sup-

ply, i.e. the air which passes through the shaking grate, is controlled by the bottom draft vent,

while the secondary air supply, i.e. the air supplied to the ﬁre across the glass window, is con-

trolled by the top draft vent. The stove’s rated heat output is 5,1 kW. The efﬁciency is 76%.

Your new Morsø stove is EN-tested and recommended to be ﬁred with wood.

The stove is intended for intermittent use.

N.B!

Wood is a material that contains a great deal of gas (approximately 75 %). The gases

are released when the wood is lit and heated up. For this reason, it is important that

the gases are ignited quickly after stoking.

If the wood just lies smouldering, especially after re-stoking, a lot of smoke is creat-

ed, which, in the worst case, may cause an explosive ignition of the gasses, result-

ing in damage to the stove.

In order to ignite the gases that are released from the wood, and to keep clear, last-

ing ﬂames during the combustion process, it is important to let in the required quan-

tity of oxygen (air supply) at all times.

The setting of the air supply, the method of ignition and the lighting intervals depend

on the draught in the chimney, the wind and weather, the amount of heat required,

the fuel, etc. This means that it may take some time before you get to know the cor-

rect functioning of the stove under any given circumstances.

Although you can ﬁre your Morsø stove with almost all kinds of wood, you should

not ﬁre with wet wood, or unseasoned wood. Wood ought to be stored under a roof

for at least 1 year, and preferably 2 years, with free access to wind. Wood should be

chopped as soon as possible after felling if it is to dry quickly. The wood can be used

once the moisture content is less than 20%. During the EN test, all stoves are tested

with wood with a moisture content of (16 ± 4)%.

Never use driftwood, as it usually has a high salt content, which damages both the

stove and the chimney. Impregnated and painted wood and chipboard emit poison-

ous smoke and fumes, so they should not be used as fuel either.

Please note that liquid fuel may not be used in the stove.

Pieces of wood with a diameter greater than 10 cm should always be chopped.

The pieces of wood should be short enough to be able to lie ﬂat over the layer of

embers, with air at both ends.

The maximum length of fuel in the stove is 25 cm.

The maximum quantity of fuel is 2 kg/hour (max. 2 pieces of wood each time you re-

stoke).

The ﬁrst few times you light the stove, the ﬁre should be moderate, so that the heat-

resistant paint can harden before ﬁring more vigorously. During the hardening phase,

the paint may develop obnoxious smoke and smell the ﬁrst time it is lit, which is very

normal. Make sure that the room is well ventilated during this period.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Morso 1452 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Morso 1452

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info