Bedienungsanleitung Morso 2B Classic (Seite 34 von 36) (Englisch, Dänisch)

744319

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

DK ENG

Reasons for overly rapid wear of internal parts

- Stove red too vigorously.

- Too little air passing through the bottom grate.

- Use of very dry wood (wood from old furniture).

- Excessive debris collection on bae plate or inner reback (see section on cleaning)

- Ash level too high in the ash pan (see section on ash).

will naturally shorten the lifespan. The aforementioned parts are all easily replaced. If the

bae plate is damaged or warped and is not replaced in time, the top plate could become

subject to excessively high temperatures, which may lead to damage here also.

Note that no unauthorised alterations to the stove design should be undertaken, and al-

ways ensure that any replacement parts purchased must be Morsø original parts.

Gaskets

The rope gaskets in the door will need regular inspection in order to ensure and maintain

full control of your stove’s burning rate; over time the rope gaskets will harden and will be-

come less airtight, at this point you will need to remove and replace with new. Use only the

genuine Morsø gasket kit, which comes with detailed replacement instructions.

NOTE: Normal wear components (inner parts) are not covered by Morsø’s extended

guarantee.

Maintenance products (Spare Parts, Glass Cleaner, Paint, Gasket Kit, etc) are all available from

your authorised Morsø dealer.

3.3 Cleaning the stove

During normal use and sweeping of your stove and chimney, a layer of ash, soot or debris can

form, particularly on the top of the bae plate or inner reback. Any deposits allowed to build-

up over time will have an insulating eect on these parts, thus restricting expansion; this ulti-

mately result in a shorter lifespan. The bae plate can easily be removed from the stove and

should be regularly checked for debris and cleaned. You must ensure that your chimney sweep

removes all soot and debris from the stove after the sweeping process.

Your chimney should be swept at least once a year; however a regular inspection of your

stovepipe and chimney will determine whether a more frequent approach should be adopt-

ed.

Ash

As noted above, there should be a layer of approximately 1 cm insulating ash in the bottom

of the combustion chamber in order to achieve a high combustion temperature. If the layer

of ash is too thick, it can be brushed down with an ash shovel, dustpan or similar tool.

Be sure to empty the ash pan before it gets completely full; if the ash level reaches the under-

side of the grate, air ow through the grate will be restricted and will lead to over-heating and

premature wear of the grate parts.

In most cases, the ash will need to be taken away by the waste disposal company. Because

embers may be concealed in the ash pan for several days, it may be necessary to store the

ash in a container made of non-ammable material before pouring it into a rubbish bag.

Ash from a wood-burning stove will not be of any benet to your garden as fertiliser. If you

have burned colour brochures, or painted or treated wood, etc., in the stove, the resulting

ash must not be poured onto soil, as it may contain heavy metals.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Morso 2B Classic Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Morso 2B Classic

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info